OEM Ford Explorer Sport Trac Seat Motor

Ford Explorer Sport Trac Seat Motor Parts Questions & Experts Answers

• Recline Motor, Driver Side
  6L2Z-14547-AA
  Q: How to service and repair the power seat motor and seat recliner motor on Ford Explorer Sport Trac?

  A: Privacy and comfort services and repairs on the power seat motor and seat recliner motor need to start with the complete removal of the front seat followed by separation of the front seat backrest. You need to disconnect the plastic rivets which fix the backrest trim cover to its inboard and outboard recliners. It is essential to be careful while pulling the backrest trim cover off the hook-and-loop strip in order to prevent damage to the backrest foam pad. Open the lower J-clip system and hook-and-loop strip of the trim cover before flipping it toward the first row of hog rings. The process of rotating the recliner shaft must be avoided when both recliners are separated since this creates synchronization problems. Disengage the one-way push clip on the inboard power recliner before pulling the recliner shaft out from the outboard direction until the inboard recliner and power recline motor are clear of each other. The power recline motor requires disconnecting its electrical connector and removing its screw and then extracting the motor from the system. To install the recliner shaft properly position it through the recliner motor and inboard recliner before possibly requiring light adjustment. Secure a new one-way push clip to the recliner shaft of the inboard power recliner while matching the recliner motor mounting hole to the screw hole before fastening it using a recliner motor bolt. The electrical protocol should be reattached to the recliner motor before rolling down the backrest trim cover with hook-and-loop strip attachment and lower J-clip activation. The backrest trim cover will be installed onto the inboard and outboard recliners before readding the plastic rivets. End the procedure by reinstalling both the front seat backrest alongside the front seat component. The SRS system should not be proved out when servicing the passenger seat. The Occupant Classification Sensor (OCS) System Zero Seat Weight Test needs to be performed and the SRS needs to be tested during final check procedures.