Other Name: Processor - Lighting Control; Headlight Control Module, Front; Lighting Control Module; Controller; Module - Lighting Control
Position: Front
Fits the following Ford Models:
Fusion | 2017-2020 | Energi Platinum, Energi SE, Energi Titanium, Platinum, Platinum Hybrid, S, S Hybrid, SE, SE Hybrid, SEL, SEL Hybrid, Sport, Titanium, Titanium Hybrid | 4 Cyl 1.5 L GAS, 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV), 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 2.7 L GAS
Police Responder Hybrid | 2019-2020 | Base | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV)
SSV Plug-In Hybrid | 2019-2020 | Base | 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV)
Other Name: Ballast Assembly; High Intensity Discharge (HID) Lighting Ballast, Front; Hid Bulb Ballast; Bulb Ballast; Ballast; Module
Position: Front
Replaces: FL3Z-13C170-A
Fits the following Ford Models:
Expedition | 2018-2021 | King Ranch, Limited, Max King Ranch, Max Limited, Max Platinum, Max SSV, Max XL, Max XLT, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS
F-150 | 2015-2020 | King Ranch, Lariat, Limited, Platinum, Police Responder, Raptor, SSV, XL, XLT | 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L DIESEL, 6 Cyl 3.3 L FLEX, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 8 Cyl 5.0 L FLEX
F-250 Super Duty | 2017-2019 | King Ranch, Lariat, Limited, Platinum, XL, XLT | 8 Cyl 6.2 L FLEX, 8 Cyl 6.7 L DIESEL
F-350 Super Duty | 2017-2019 | King Ranch, Lariat, Limited, Platinum, XL, XLT | 8 Cyl 6.2 L FLEX, 8 Cyl 6.7 L DIESEL
Q: How to service and repair the Light Control Module on Ford Crown Victoria?
A: In order to fix the Lighting Control Module (LCM), you need to remove the battery, download the configuration data to a diagnostic tool, and take off the LH instrument panel lower insulator. Then remove LCM, disconnecting connector and screws. To install it, one should do the process in a reverse order and download the configuration to the new module.
Q: How to service the Light Control Module for exterior lighting on Ford Flex?
A: To install the exterior lighting module, you will have to take off the headlamp assembly first. Then loosen four screws which are attached to the ballast and disconnect the electrical connectors. The procedure to re install the ballast is simple, do the reverse of the steps that were used to remove it.