How to service and repair the front brake pads on Lincoln MKZ?

The initial step to service and repair the front brake pads requires using accepted DOT 3 brake fluid because it safeguards brake components from permanent damage. You must be aware of the master cylinder reservoir fluid level and drain fluid until reaching half full in order to proceed. Place the vehicle onto a hoist rack in neutral position. Sight hole probing to retract pistons should be avoided because doing so leads to caliper component damage. Allowing the brake caliper to depend from the brake hose will lead to hose damage. Supported by mechanic's wire, remove the caliper guide pin bolts which are part of the two components. The procedure continues with removal of two brake pad retraction springs before extracting the brake pads alongside brake pad shims and stainless steel shims. Check them for any wear or contamination present. Detach the brake pad slides along with their four brake pad slide clips. Installation begins when you put in place the four brake pad slide clips first. Store the caliper piston and boots in a safe position while using the appropriate tool to push the pistons inside the caliper. Apply the provided grease to the pad backing plate and shims according to indications while ensuring measurement of grease for the back of the brake pad and inner piston stainless steel shim and outer stainless steel shim. Place the cut shim on the inside brake pad and direct it to face ahead with confirmation through bottom sideweir of the shim hole. Mount the brake pad shims together with stainless steel shims onto brake pads followed by attaching the two brake pad retraction springs. Position the caliper guide pin boots properly on the anchor plate so contamination does not occur by placing the boot lip beneath the anchor plate extension. Install the brake caliper while keeping the brake caliper hose untwisted before securing the two guide pin bolts to a torque setting of 27 Nm (20 ft. lbs.). Normal brake operation must be tested after filling the brake master cylinder reservoir with clean specified brake fluid.

OEM Lincoln MKZ Brake Pads

Disc Brake Pad Set

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Brake Pads found

View related parts
Lincoln MKZ Brake Pads
Part Number: HP5Z-2001-C
$104.54 MSRP: $152.17
You Save: $47.63 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Kit; Disc Brake Pad Set; Front Pads
- Replaces: BRF-1544, HP5Z-2001-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2017-2020 Lincoln MKZ | Black Label, Reserve, Reserve II, Select | 6 Cyl 3.0 L GAS
View related parts
Lincoln MKZ Brake Pads, Front
Part Number: 6U2Z-2V001-F
$46.59 MSRP: $66.65
You Save: $20.06 (31%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Front Pads
- Position: Front
- Replaces: 6U2Z-2V001-D, BR-1164-B, 9E5Z-2001-A, 6E5Z-2001-C, 6E5Z-2001-B, BRF-1164, 7E5Z-2001-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2012 Lincoln MKZ | Base, Hybrid | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L GAS
View related parts
Lincoln MKZ Brake Pads, Rear
Part Number: DG9Z-2200-MA
$66.29 MSRP: $99.98
You Save: $33.69 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Pad - Brake; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Disc Brake Pad Set; Rear Pads
- Position: Rear
- Replaces: BRF-1555, DG9Z-2200-M, BRF-30, BRF-1499, DG9Z-2200-K, DG9Z-2200-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2016 Lincoln MKZ | Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV)
View related parts
Lincoln MKZ Brake Pads, Rear
Part Number: 6U2Z-2V200-B
$45.79 MSRP: $66.65
You Save: $20.86 (32%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Rear; Rear Pads
- Manufacturer Note: Ford Retail Spec
- Position: Rear
- Replaces: 6E5Z-2200-C, BE5Z-2200-A, 6E5Z-2200-B, BRF-24, 9E5Z-2200-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2012 Lincoln MKZ | Base, Hybrid | 4 Cyl 2.5 L FULL HYBRID EV-GAS (FHEV), 6 Cyl 3.5 L GAS
View related parts
Lincoln MKZ Brake Pads, Rear
Part Number: DG9Z-2200-F
$66.29 MSRP: $99.98
You Save: $33.69 (34%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Pad - Brake; Disc Brake Pad Set, Rear; Disc Brake Pad Kit; Rear Pads; Disc Brake Pad Set
- Position: Rear
- Replaces: BRF-1434, DG9Z-2200-D, BRF-1500
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2020 Lincoln MKZ | Base, Black Label, Black Label Hybrid, Hybrid, Premiere, Premiere Hybrid, Reserve, Reserve Hybrid, Reserve I, Reserve I Hybrid, Reserve II, Reserve II Hybrid, Select, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.0 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.7 L GAS
View related parts
Lincoln MKZ Brake Pads, Front
Part Number: DG9Z-2001-M
$65.09 MSRP: $99.98
You Save: $34.89 (35%)
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Disc Brake Pad Kit; Disc Brake Pad Set; Front Pads
- Position: Front
- Replaces: BRF-1502, BRF-33, DG9Z-2001-B, BRF-1533, DG9Z-2001-D, DG9Z-2001-G
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2020 Lincoln MKZ | Black Label Hybrid, Hybrid, Premiere Hybrid, Reserve Hybrid, Reserve I Hybrid, Reserve II Hybrid, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV)
View related parts
Lincoln MKZ Brake Pads, Front
Part Number: DG9Z-2001-F
$66.29 MSRP: $99.98
You Save: $33.69 (34%)
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Disc Brake Pad Kit; Front Pads; Disc Brake Pad Set
- Manufacturer Note: Warranty Eligible
- Position: Front
- Replaces: BRF-31, DG9Z-2001-A, DG9Z-2001-C, BRF-1501
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2020 Lincoln MKZ | Base, Black Label, Premiere, Reserve, Reserve I, Reserve II, Select | 4 Cyl 2.0 L GAS, 6 Cyl 3.7 L GAS
View related parts
Lincoln MKZ Brake Pads, Rear
Part Number: DG9Z-2200-R
$65.09 MSRP: $99.98
You Save: $34.89 (35%)
ADD TO CART
Product Specifications
- Other Name: Pad - Brake; Disc Brake Pad Set, Rear; Rear Pads
- Position: Rear
- Replaces: BRF-1492, DG9Z-2200-H, DG9Z-2200-C, BRF-1497, BRF-35, DG9Z-2200-G
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2013-2020 Lincoln MKZ | Black Label Hybrid, Hybrid, Premiere Hybrid, Reserve Hybrid, Reserve I Hybrid, Reserve II Hybrid, Select Hybrid | 4 Cyl 2.0 L FULL HYBRID EV-GAS (FHEV)
View related parts
Lincoln MKZ Brake Pads, Front
Part Number: G3GZ-2001-C
$66.29 MSRP: $99.98
You Save: $33.69 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Kit - Brake Lining; Disc Brake Pad Set, Front; Disc Brake Pad Kit; Front Pads; Disc Brake Pad Set
- Manufacturer Note: Warranty Eligible
- Position: Front
- Replaces: BRF-1536, G3GZ-2001-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2017-2020 Lincoln MKZ | Black Label, Reserve, Reserve II, Select | 6 Cyl 3.0 L GAS

Lincoln MKZ Brake Pads

Welcome to our website where you can discover high-quality, genuine Lincoln MKZ Brake Pads. We offer an extensive inventory of OEM Lincoln MKZ Brake Pads at affordable prices. We are committed to providing top-rated customer service along with prompt delivery.

Lincoln MKZ Brake Pads Parts Questions & Experts Answers

Brake Pads, Front
6U2Z-2V001-F
Q: How to service and repair the front brake pads on Lincoln MKZ?
A: The initial step to service and repair the front brake pads requires using accepted DOT 3 brake fluid because it safeguards brake components from permanent damage. You must be aware of the master cylinder reservoir fluid level and drain fluid until reaching half full in order to proceed. Place the vehicle onto a hoist rack in neutral position. Sight hole probing to retract pistons should be avoided because doing so leads to caliper component damage. Allowing the Brake Caliper to depend from the brake hose will lead to hose damage. Supported by mechanic's wire, remove the caliper guide pin bolts which are part of the two components. The procedure continues with removal of two brake pad retraction springs before extracting the brake pads alongside brake pad shims and stainless steel shims. Check them for any wear or contamination present. Detach the brake pad slides along with their four brake pad slide clips. Installation begins when you put in place the four brake pad slide clips first. Store the caliper piston and boots in a safe position while using the appropriate tool to push the pistons inside the caliper. Apply the provided grease to the pad backing plate and shims according to indications while ensuring measurement of grease for the back of the brake pad and inner piston stainless steel shim and outer stainless steel shim. Place the cut shim on the inside brake pad and direct it to face ahead with confirmation through bottom sideweir of the shim hole. Mount the brake pad shims together with stainless steel shims onto brake pads followed by attaching the two brake pad retraction springs. Position the caliper guide pin boots properly on the anchor plate so contamination does not occur by placing the boot lip beneath the anchor plate extension. Install the brake caliper while keeping the brake caliper hose untwisted before securing the two guide pin bolts to a torque setting of 27 Nm (20 ft. lbs.). Normal brake operation must be tested after filling the brake master cylinder reservoir with clean specified brake fluid.