OEM Mercury Monterey Key Fob

Mercury Monterey Key Fob Parts and Q&A

• Transmitter
  3F2Z-15K601-AA
  Q: How to program the remote keyless entry (RKE) transmitters and Key Fob on Mercury Monterey?

  A:

  A successful remote keyless entry transmitter programming session must happen at the same time for all transmitters. Begin by using vehicle electronic unlock methods through RKE along with RKE keypad (if equipped) or door lock control switch with the driver door still open. The process to enter program mode begins by rotating the key from OFF to RUN eight times during a ten-second period with the last stop being RUN. A successful mode entry will activate door locking followed by unlocking. An RKE transmitter needs 20 seconds to press any button to lock then unlock the doors for programming confirmation. Perform this procedure for every RKE transmitter. Press the button once again after a couple of waiting seconds while the door locks remain unresponsive. Determine the problem by checking that you have programmed no exceeding the permitted RKE transmitter number. The programming mode exits when the key reaches OFF position, passes 20 seconds in programming mode after key entry, reaches the maximum transmitter limit, or whenever the key completes 20 seconds in programming mode after a previous transmitter programming.
• Transmitter
  8L3Z-15K601-B
  Q: How to remove and replace the keyless entry transmitter and Key Fob for the sliding door latch remote control on Mercury Monterey?

  A:

  The first step to change the keyless entry transmitter for the sliding door latch remote control starts with removing the sliding door trim panel. Following the removal of three sliding door latch screws you should tighten them to 9 Nm (80 lb-in) during reinstallation. Set the sliding door latch outside the door frame while separating the electrical connector that controls the sliding door detent switch if present. You need to uninstall three sliding door remote control bolts that are located inside the door frame while tightening them to 9 Nm (80 lb-in) when you put them back. Tighten each one of the three sliding door remote control bolts to 9 Nm (80 lb-in) before putting them back. You must disconnect the component that operates the sliding door exterior handle and the component that operates the sliding door interior handle by opening the clip. Place the sliding door remote control before disconnecting the sliding Door Lock Actuator and every sliding door latch actuator electrical connector present on the vehicle. Before reinstalling the sliding door remote control you must finish by completing the procedure in reverse order.