OEM Mercury Monterey Transmitter

Mercury Monterey Transmitter Parts and Q&A

• Transmitter
  8L3Z-15K601-B
  Q: How to remove and replace the keyless entry transmitter for the sliding door latch remote control on Mercury Monterey?

  A:

  The first step to change the keyless entry transmitter for the sliding door latch remote control starts with removing the sliding door trim panel. Following the removal of three sliding door latch screws you should tighten them to 9 Nm (80 lb-in) during reinstallation. Set the sliding door latch outside the door frame while separating the electrical connector that controls the sliding door detent switch if present. You need to uninstall three sliding door remote control bolts that are located inside the door frame while tightening them to 9 Nm (80 lb-in) when you put them back. Tighten each one of the three sliding door remote control bolts to 9 Nm (80 lb-in) before putting them back. You must disconnect the component that operates the sliding door exterior handle and the component that operates the sliding door interior handle by opening the clip. Place the sliding door remote control before disconnecting the sliding door lock actuator and every sliding door latch actuator electrical connector present on the vehicle. Before reinstalling the sliding door remote control you must finish by completing the procedure in reverse order.
• Transmitter
  3F2Z-15K601-AA
  Q: How to program the keyless entry remote transmitters on Mercury Monterey?

  A:

  The keyless entry remote transmitter programming process requires executing the operation with all transmitters at the same time. Begin by using either remote transmitter or keyless entry keypad or the door lock control switch to electronically unlock the vehicle while keeping the driver door open. To enter the programming mode turn the key from OFF to RUN position exactly eight times during a ten second time period; the successful entry will result in door locks then followed by door unlocks. The successful programming confirmation occurs when pressing any remote transmitter button produces door lock and unlock behavior during the first 20 seconds of programming. The programming process should be repeated for every remote device. Press the button once more after waiting for a couple of seconds if the door locks fail to respond. Check inspection and verification to verify that the maximum limit of remote transmitters has not been surpassed when remote device response fails to appear. The key turning to OFF position triggers exiting programming mode after waiting 20 seconds from the time of entry or completing programming of every transmitter or reaching the transmitter allowance limit.