Ford F5RZ-2A635-A
Rear Cable

Service and repair operations on the parking brake cable require starting with parking brake release and loosening the rear wheel nuts. Support the vehicle as you elevate it while taking off the control for the parking brake and removing the wheel. Before detaching the muffler inlet pipe exhaust hanger insulator and the left-hand muffler exhaust hanger insulator it is crucial to sustain the muffler assembly with an appropriate jack stand. Right-hand rear muffler exhaust hanger insulator must be disconnected first when working on SVT vehicles before disconnecting the exhaust pipe from its insulator position. First remove the rear section of exhaust system heat shield then detach the rear brake cables from the equalizer. A process for vehicle rear disc brake systems includes pulling back the parking brake lever followed by disconnecting the cable from the brake lever and removing the cable clip then taking out the cable. Drum brake vehicles require rear brake shoe removal alongside the detachment of the backing plate brake cable by unfolding its clip. Remove the rear brake cable from its clips as the last step. The installation process requires you to set the parking brake control self-adjust mechanism preload through the complete lift of the parking brake control lever followed by performing removal steps in reverse order.

A worker should begin by loosening the wheel nuts and releasing the parking brake before raising the vehicle for service and repair of the parking brake cable. Protect the exhaust pipe while eliminating the wheel before taking off the rear muffler. The procedure begins by removing the rear section of exhaust system heat shield while uneasing the rear cables from the equalizer. To work on rear disc brake parking cables begin by pulling back the parking brake lever then unhook the cable from its lever connection followed by removing the conduit retaining clip before taking out cable and conduit. The parking brake conduit detachments from the backing plate require use of a retaining clip compressor to release the clip which allows removal of the cable. Every vehicle requires a complete removal of its rear cable and conduit from their body clamps. The installation starts with performing the removal steps in reverse order while ensuring the adjustment of the parking brake through complete lifting of the control lever after component installation.

Service and repair operations on the parking brake cable require starting with parking brake release and loosening the rear wheel nuts. Support the vehicle as you elevate it while taking off the control for the parking brake and removing the wheel. Before detaching the muffler inlet pipe exhaust hanger insulator and the left-hand muffler exhaust hanger insulator it is crucial to sustain the muffler assembly with an appropriate jack stand. Right-hand rear muffler exhaust hanger insulator must be disconnected first when working on SVT vehicles before disconnecting the exhaust pipe from its insulator position. First remove the rear section of exhaust system heat shield then detach the rear brake cables from the equalizer. A process for vehicle rear disc brake systems includes pulling back the parking brake lever followed by disconnecting the cable from the brake lever and removing the cable clip then taking out the cable. Drum brake vehicles require rear brake shoe removal alongside the detachment of the backing plate brake cable by unfolding its clip. Remove the rear brake cable from its clips as the last step. The installation process requires you to set the parking brake control self-adjust mechanism preload through the complete lift of the parking brake control lever followed by performing removal steps in reverse order.

The service and repair of front parking brake cable and conduit requires users to start by releasing the parking brake lever then loosening wheel nuts followed by vehicle elevation and support. Before removing the wheel take necessary measures to support the exhaust pipe as you uninstall the rear muffler. Remove the rear part of the exhaust system heat shield before detaching rear cables from the equalizer system. The front parking brake cable servicing starts with parking brake lever pullback to detach the cable from the lever after disconnecting them followed by conduit retaining clip removal before cable and conduit extraction. You must remove rear brake shoes then extract the parking brake conduit from backing plate by pushing retaining clip before you disconnect cable and conduit when working on vehicles equipped with rear drum brakes. The body clips must be cleared of the rear cable and conduit for every vehicle. Reverse the removal steps and complete adjustment of the parking brake by raising the control lever to maximum height after the installation process.

Remove the rear cable and conduit from the body clips.