Ford 3W1Z-6038-BA
Front Mount, Driver Side

The service and repair process for the transmission mount starts with disabling the fire suppression system when present on the vehicle. The first step requires removing the transmission support crossmember before proceeding to remove the transmission support insulator. The installation process of new components requires the same reverse order of uninstallation steps and should include fastener torque to 80 Nm (59 ft. lbs.). Owners must repower their fire suppression system after completion when it is present on their vehicle.

Depowering the fire suppression system is the first step to perform transmission mount service because it prevents serious personal injury. The first step is to disconnect the transmission support crossmember followed by removal of the transmission support insulator. After reversing the removal steps install the components while tightening them to 90 Nm (66 lb-ft). After finishing installation check that your vehicle is equipped with a firefighting system because you should activate it while following safety rules to stay safe against injuries.

The service process for transmission mounts starts with transmission support crossmember removal followed by removing the transmission support insulator. The new parts should be installed through the steps of reverse removal order.

Proceeding with left-hand engine mount service you should perform ventilation procedures on the fire suppression system to reduce risks of serious injury. Place the vehicle at neutral gear before setting it on the hoist. The work starts by taking out the generator followed by attaching the Engine Lifting Bracket and the Engine Support Bar. Proceed by removing the oil filter then discard it while performing oil lubrication on the O-ring seal of the new filter with fresh engine oil before installation. Secure both left-hand and right-hand lower engine mount nuts with 90 Nm (66 lb-ft) torque before reinstalling them. Raising the engine using the Engine Support Bar allows you to remove the three bolts on the left-hand engine mount before torquing these bolts to 70 Nm (52 lb-ft) upon reinstallation. Repower the vehicle with its fire suppression system by following the safety and operating procedures exactly as directed to ensure proper functionality.

Tighten them to 70 Nm (52 lb-ft).

Remove the three bolts securing the left-hand engine mount, which should be tightened to 70 Nm (52 lb-ft) during installation.

Repower the fire suppression system following the necessary safety procedures.

Reverse the removal procedure and ensure to tighten the fasteners to 90 Nm (66 lb-ft).

Repower the system, adhering to all safety warnings and procedures to avoid any risk of injury.

Remove the transmission support insulator.

Begin by removing the transmission support crossmember.

Reverse the steps taken during removal.