Ford F77Z-17618-A
Washer Reservoir, Front

The repair and servicing of the coolant reservoir must start by removing the air cleaner outlet tube and removing the engine air cleaner (ACL). Position the speed control servo aside by removing the bolt first. The service requires users to disconnect the windshield washer hose found beneath the dash panel but users should use a hose plug to block it. Disconnect the electrical connector for the windshield washer pump located on top of the windshield washer reservoir. Proceed by resetting the clamp before disconnecting the radiator overflow hose from the radiator filler neck while plugging the hose. To extract the radiator coolant recovery reservoir and the windshield washer reservoir simply remove their respective two nuts and bolts. The first step of installation involves putting the radiator coolant recovery reservoir and windshield washer reservoir into place before securing the bolts and two nuts. Use the clamp to fix the radiator overflow hose to its connection at the radiator filler neck. Connect the electrical connection of the windshield washer pump hose to both the reservoir and the dash-mounted hose. Conclude the operation by correctly positioning the speed control servo along with its bracket then install the bolt while filling the cooling system.

The air cleaner outlet tube together with the engine air cleaner must be removed before servicing the coolant expansion tank. Disengage the bolt holding the speed control servo after which move the parts away. You should disconnect the windshield washer hose from under the dash panel yet plugging its end will help prevent leakage. The electrical connector of the windshield washer pump requires disconnecting from the windshield washer reservoir while also disconnecting and plugging the overflow hose. The two nuts and bolts securing the coolant expansion tank need to be removed last. The installation procedure requires reversing all steps that were used for removal.

Ensure that the rubber grommet is not damaged.

Position the air filter housing aside.

Remove the two nuts and two bolts, then disconnect the washer motor hose to take out the radiator coolant recovery reservoir.

Remove the two nuts and two bolts securing the bottle, and take it out.

Disconnect the electrical connector from the windshield washer reservoir pump and position the air filter housing aside.

First, remove the air cleaner outlet tube and disconnect the connector.

Remove the mounting bolts to take out the coolant recovery reservoir from the vehicle.

Disconnect the hoses and drain the engine coolant into a suitable container.

Reverse the removal steps, noting that the windshield washer reservoir and the washer pump are to be replaced independently.

Remove the engine air cleaner.