Ford F7RZ-2C204-AB
ABS Sensor

You should service the rear ABS sensor by loosening wheel nuts followed by vehicle lift support before you remove the wheel. The first step requires removing the ABS sensor but stopping to disconnect its wiring harness from its support brackets and clips. During the service of the rear ABS sensor you should first lower the vehicle then lift the rear seat cushion by moving it towards the backrest while pulling it up. The screw needs removal before you push the trim to a side to gain access to the ABS sensor electrical connector which you detach by pulling the cable through the grommet. The installation requires performing the steps in reverse order to those used in removal.

You should start servicing the rear ABS sensor by loosening each wheel nut following vehicle lifting and suspension support. Beginning the service requires wheel removal and sensor separation followed by disconnecting the sensor wires from both brackets and clips. Begin by lowering the vehicle and then engage in two steps to raise the rear seat cushion by pushing it towards the backrest followed by pulling it up. Unscrew the trim before pushing it aside and draw the ABS sensor electrical connector through its grommet by pulling back the cable. The installation process should follow the steps of the removal process in reverse order.

One should start servicing and repairing the front ABS sensor by first loosening wheel nuts followed by raising the vehicle and installing support. First disconnect the ABS sensor by removing the wheel while removing its harness wiring from the support bracket along with its clips. You should disconnect the lower splash shield from vehicles which have the 2.5L engine installed. Besides the lower splash shield of vehicles with a 2.0L engine owners must also remove it. The service requires disconnection of the ABS sensor electrical connector. Implementation of the new sensor requires the same reverse order of removal steps while following correct installation methods for all vehicle types.

Service of the rear ABS sensor requires first loosening wheel nuts before raising and supporting the vehicle. Disconnect the sensor from its wheel base while removing the wheel by removing the knots on the wheel nuts. Confirm that the sensor wiring dissociates from its support brackets and clips. You should raise the rear seat cushion after lowering the vehicle by both pushing it towards the backrest and then pulling it upwards. Reach the ABS sensor electrical connector by removing the screw and sliding aside the trim. After pulling the cable through the grommet, continue the installation process. Consult the installation instructions to perform the reverse steps of removal.

Pull the cable through the grommet to disconnect it.

Begin by loosening the wheel nuts.

Remove the fender splash shield.