Ford 6H6Z-6038-BA
Transmission Mount, Driver Side

Starting the task to replace or remove the engine mount requires positioning the vehicle on a hoist with NEUTRAL gear selected. Start by taking off the engine coolant degas bottle followed by attaching the Engine Support Bar at the front and rear engine lifting eyes. The procedure for installment and removal requires you to detach both the bolt and radio frequency interference capacitor then tighten the bolt to 10 Nm (89 lb-in) before reinstalling. The engine mount bracket bolt requires tightening to 115 Nm (85 lb-ft) when installing the part. Lift the engine using the Engine Support Bar to 25 mm (0.98 in) then take out the two engine mount bracket nuts before torquing them to 103 Nm (76 lb-ft). Next remove the engine mount securing nut and bolts and follow the installation by tightening them to 55 Nm (41 lb-ft). You should lower the engine by 25 mm (0.98 in) before you take out the engine mount bracket to avoid A/C tube contact with the bracket. Reverse the process of removal for reinstallation of the components.

Remove the lower 2 transaxle insulator-to-frame bolts.

Lower the vehicle and remove the battery and battery tray by disconnecting the positive battery cable retainer and removing the battery tray nut and bolt.

Install new studs ensuring they are properly seated in the case, and tighten to 63 Nm (46 lb-ft).

Remove the engine coolant degas bottle.