FordParts
My Garage
My Account
Cart
OEM 2000 Lincoln Continental A/C Accumulator
Accumulator- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 A/C Accumulator found
2000 Lincoln Continental Drier Part Number: XF3Z-19C836-BA
Product Specifications- Other Name: Accumulator Assembly - Air Intake; Drier Desiccant Element; A/C Receiver Drier; A/C Accumulator; Accumulator; Accumulator Assembly - Air Conditioning
- Manufacturer Note: Tank only, for switch refer to 19E561, w/integral A/C
- Base No.: 19C836
- Item Weight: 3.20 Pounds
- Item Dimensions: 3.9 x 7.3 x 12.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XF3Z-19C836-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Lincoln Continental A/C Accumulator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Lincoln Continental A/C Accumulator available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Lincoln Continental A/C Accumulator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Lincoln Continental A/C Accumulator Parts Q&A
- Q: How to Service and Repair the A/C Accumulator on 2000 Lincoln Continental?A: One should start accumulator HVAC servicing by removing the radiator upper sight shield. We should carry out the Refrigerant Discharging and Recovery Procedure. The first step is to remove screws from the windshield washer fluid reservoir filler which makes way for removal of the right-hand fender support brace following screw removal. The power steering fluid reservoir needs repositioning after screwholes removal before taking out the air suspension air compressor and drier assembly while referencing the Electronic Level Control document. Disconnect the A/C cycling switch electrical connector while detaching the suction accumulator/drier spring lock coupling from the evaporator to compressor suction line then separate the wrap-around clip screw from this same line. Start by taking out the degas bottle screw and nut before extracting both nuts from A/C hose support bracket and A/C accumulator tube support clip. Screw loosening will lift the suction accumulator/drier out from its A/C accumulator bracket position while removal of the evaporator to accumulator tube spring lock coupling from the suction accumulator/drier must be completed before removing the A/C cycling switch. A proper installation requires the reversal of uninstallation steps while using PAG compressor oil or YN-12c and F7AZ-19589-DA or WSH-M1C231-B equivalent lubricants to meet Ford specifications and applying similar PAG compressor oil to the O-ring seal.