FordParts
My Garage
My Account
Cart
OEM 2000 Mercury Sable Exhaust Manifold
Engine Exhaust Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Exhaust Manifolds found
2000 Mercury Sable Exhaust Manifold, Driver Side Part Number: 4F1Z-9431-AA
$132.62 MSRP: $180.47You Save: $47.85 (27%)Product Specifications- Other Name: Manifold Assembly - Exhaust; Exhaust Manifold, Left; Manifold
- Position: Driver Side
- Base No.: 9431
- Item Weight: 11.80 Pounds
- Item Dimensions: 25.1 x 9.9 x 6.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4F1Z-9431-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Manifold Assembly - Exhaust; Exhaust Manifold, Left; Manifold
- Position: Driver Side
- Base No.: 9431
- Item Weight: 11.40 Pounds
- Item Dimensions: 20.1 x 9.7 x 6.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: YF1Z-9431-GB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Mercury Sable Exhaust Manifold
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Mercury Sable Exhaust Manifold available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Mercury Sable Exhaust Manifold as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Mercury Sable Exhaust Manifold Parts Q&A
- Q: How to service and repair the right-hand exhaust manifold on 2000 Mercury Sable?A: The first step for right-hand exhaust manifold service and repair requires disconnecting the battery ground cable. Start by taking off the cowl vent screen along with the cowl extension and then disconnect the Oxygen Sensor (HO2S) Electrical connector. Remove first the exhaust manifold to Exhaust Gas Recirculation (EGR) valve tube then the exhaust manifold heat shield by unbolt it. Detachment of the exhaust manifold from the catalytic converter starts by removing all bolts before extracting the right-hand exhaust manifold together with the exhaust manifold gasket which gets discarded. New exhaust manifold gaskets should be installed before fitting the exhaust manifold and following a two-step bolt-tightening procedure from 10 Nm (89 inch lbs.) to 22 Nm (16 ft. lbs.). Start by attaching the bolts of the catalytic converter and afterwards install and bolt the exhaust manifold heat shield. To complete the installation the technician must connect the exhaust manifold to the EGR valve tube and restore HO2S electronic wiring while reinstalling cowl vent screen and cowl extension prior to reconnecting the ground cable.