FordParts
My Garage
My Account
Cart
OEM 2002 Lincoln LS Canister Purge Valve
Vapor Canister Purge Valve EVAP- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Canister Purge Valves found
2002 Lincoln LS Purge Valve Part Number: XW4Z-9D289-AG
Product Specifications- Other Name: Tube Assembly - Fuel Vapor; Vapor Canister Vent Solenoid; Canister Purge Valve
- Item Weight: 1.00 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW4Z-9D289-AG
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Lincoln LS Vent Control Solenoid Part Number: XW4Z-9F945-AA
Product Specifications- Other Name: Solenoid Assembly; Vapor Canister Purge Solenoid; Vapor Canister Vent Solenoid; Solenoid
- Base No.: 9F945
- Item Weight: 2.20 Pounds
- Item Dimensions: 6.3 x 6.2 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: XW4Z-9F945-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2002 Lincoln LS Canister Purge Valve
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2002 Lincoln LS Canister Purge Valve available at FordPartsDeal.com. You can confidently purchase our OEM 2002 Lincoln LS Canister Purge Valve as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2002 Lincoln LS Canister Purge Valve Parts Q&A
- Q: How to Service and Repair the Canister Purge Valve on 2002 Lincoln LS?A: The first step to service and repair the canister purge valve includes disconnecting the battery ground cable due to electrical safety reasons. First, remove the evaporative canister purge valve cover and proceed to disconnect the connector and vacuum hose, then the evaporative emission (EVAP) return tube and EVAP canister purge outlet tube. The EVAP canister purge valve needs removal after disconnecting its components. Perform the opposite order of steps used for removal to install the components. A leak test must come after installation as part of the evaporative emission verification drive cycle procedure. Bear in mind the necessity to use Merpol(R) for sealing the O-ring during assembly steps.