FordParts
My Garage
My Account
Cart
OEM 2003 Lincoln LS Timing Cover
Engine Timing Cover- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Timing Covers found
2003 Lincoln LS Timing Cover, Front Part Number: 3W4Z-6019-AA
Product Specifications- Other Name: Cover - Cylinder Front; Front Cover
- Position: Front
- Base No.: 6019
- Item Weight: 11.80 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3W4Z-6019-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2003 Lincoln LS Timing Cover, Front Part Number: 2W9Z-6019-AA
Product Specifications- Other Name: Cover - Cylinder Front; Engine Timing Cover; Front Cover
- Position: Front
- Base No.: 6019
- Item Weight: 6.90 Pounds
- Item Dimensions: 9.1 x 17.0 x 3.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2W9Z-6019-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2003 Lincoln LS Timing Cover
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2003 Lincoln LS Timing Cover available at FordPartsDeal.com. You can confidently purchase our OEM 2003 Lincoln LS Timing Cover as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2003 Lincoln LS Timing Cover Parts Q&A
- Q: How to service and repair the engine front timing cover on 2003 Lincoln LS?A: Start repair and servicing of the engine front cover by draining the cooling system engine fluid together with engine oil. Rephrase the following sentence: The workshop procedure begins with valve cover removal starting from left then right followed by coolant fan and crankshaft pulley before moving onto seal and compressor units and the pump. Drain the reservoir contents while disconnecting the lower radiator-to-thermostat housing hose and heater hose and power steering reservoir hose. During removal of the Power Steering Pressure (PSP) switch you should note that the concealed bolt requires accessing the power steering pump to complete the task. Proceed by removing the power steering pump bracket together with the generator bracket then disconnect all five harness clips before removing the engine front cover according to the set bolt order. The sealing surface should be cleaned by means of a plastic scraping tool and metal surface cleaner but avoid using abrasive tools to prevent damage. After the designated area application of silicone gasket and sealant, the engine front cover must remain secured inside four minutes. However, if it is not secured, clean the sealing area and let it dry. Secure the engine front cover onto the cylinder block with the bolts in place before performing a two-step tightening process starting from 5 Nm (44 inch lbs.) to 10 Nm (89 inch lbs.). Connect each generator and power steering pump bracket before installing the power steering pump by securing the PSP switch and power steering reservoir hose along with a heater hose and a lower radiator hose at the thermostat housing. To finish the installation users must add the stud bolt.