FordParts
My Garage
My Account
Cart
OEM 2005 Lincoln LS Oil Cooler
Engine Oil Cooler- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Oil Cooler found
2005 Lincoln LS Oil Cooler Part Number: 2W9Z-6A642-EA
Product Specifications- Other Name: Oil Cooler Assembly; Engine Oil Cooler
- Manufacturer Note: For Coolant Hoses To Oil Cooler, Refer To 8286 Lower Radiator Hose
- Base No.: 6A642
- Item Weight: 5.40 Pounds
- Item Dimensions: 8.5 x 6.1 x 5.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 2W9Z-6A642-EA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2005 Lincoln LS Oil Cooler
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2005 Lincoln LS Oil Cooler available at FordPartsDeal.com. You can confidently purchase our OEM 2005 Lincoln LS Oil Cooler as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2005 Lincoln LS Oil Cooler Parts Q&A
- Q: How to service and repair the oil cooler on 2005 Lincoln LS?A: Start the repair or service of the oil cooler by hoisting the vehicle into a neutral position and disconnecting the battery ground cable first. The first step requires draining both engine cooling system fluid and engine oil before removing the two coolant hoses leading to the oil cooler. Check for metal or aluminum material in the oil cooler because this points to mechanical causes after removing its oil filter and its gasket. Disassemble the oil cooler bolt to reveal the components while discarding its gasket afterward inspect the oil cooler separately. Thoroughly check both the gasket along with the surfaces for impurities before applying clean engine oil to the gasket. Install the oil cooler onto its place using a new gasket while fitting the bolt by rotating the cooler until its locating pin reaches the stop before tightening the bolt to 60 Nm (44 ft. lbs.). Place a new gasket under clean engine oil and position it onto the new oil filter until the seal touches the surface. Then employ an oil filter strap wrench and tighten the filter 270 degrees beyond normal. The two coolant hoses should be connected to the oil cooler and then clean engine oil needs to be installed before reconnecting the battery ground cable. Proceed with filling the engine cooling system while bleeding correctly to prevent any damages.