FordParts
My Garage
My Account
Cart
OEM 2006 Ford Crown Victoria Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Water Pump found
2006 Ford Crown Victoria Water Pump Part Number: 5W7Z-8501-AA
$65.59 MSRP: $105.82You Save: $40.23 (39%)Product Specifications- Other Name: Pump Assembly - Water; Engine Water Pump; Water Pump Assembly
- Replaced by: 9W7Z-8501-A
- Replaces: YW7Z-8501-BB
- Base No.: 8501
- Item Weight: 3.00 Pounds
- Item Dimensions: 5.8 x 5.6 x 5.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5W7Z-8501-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Ford Crown Victoria Water Pump
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Ford Crown Victoria Water Pump available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Ford Crown Victoria Water Pump as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Ford Crown Victoria Water Pump Parts Q&A
- Q: How to Service and Repair the Water Pump on 2006 Ford Crown Victoria?A: A repair or service procedure of the coolant pump starts with disengaging the fire suppression system when present before draining the cooling system. First tighten the four bolts that secure the coolant pump pulley then detach the accessory drive belt. Start by removing four bolts which secure the coolant pump pulley followed by four bolts taking hold of the coolant pump assembly while discarding the O-ring seal. The installation requires tightening the bolts to 25 Nm (18 ft. lbs.) while installing the new O-ring seal that should use clean engine coolant. Protect the seal by avoiding any rotation of the pump housing. After the procedure you should reverse all the steps of removal and enable power to the fire suppression system if it exists. To finalize the procedure you must perform a cooling system fill and bleed operation.