OEM 2006 Ford Focus Vehicle Speed Sensor

2006 Ford Focus Vehicle Speed Sensor Parts Q&A

• Q: How to service and repair the Vehicle Speed Sensor on the Output Shaft on 2006 Ford Focus?

  A: Service and repair procedures start with placing the vehicle in neutral position and hoisting it up before proceeding with the OSS sensor service. For access to the OSS sensor start by installing a drain pan at its location and disconnect the electrical connector before removing the sensor bolt for sensor extraction. Check for any damage on the OSS bore then evaluate the O-ring seal condition. Replace the O-ring with a new one if it shows wear. The installation of an OSS sensor requires a light coating with clean transmission fluid on the O-ring before installation. Position and tighten the OSS sensor to 10 Nm (89 inch lbs.) before reconnecting the electrical connector. Examine the vehicle position then measure the transmission fluid amount before adding proper automatic transmission fluid when needed. Drive the engine until you complete a gear position test for proper functioning of the system.