FordParts
My Garage
My Account
Cart
OEM 2006 Mercury Montego Evaporator
A/C Evaporator Core- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Evaporator found
2006 Mercury Montego Evaporator Core, Front Part Number: 5F9Z-19860-CA
$134.12 MSRP: $185.54You Save: $51.42 (28%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Core - Air Conditioning Evaporator; A/C Evaporator Core, Front; A/C Evaporator Core Repair Kit; A/C Evaporator Core; A/C Evaporator; Evaporator
- Position: Front
- Base No.: 19860
- Item Weight: 4.60 Pounds
- Item Dimensions: 9.8 x 14.5 x 12.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5F9Z-19860-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2006 Mercury Montego Evaporator
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2006 Mercury Montego Evaporator available at FordPartsDeal.com. You can confidently purchase our OEM 2006 Mercury Montego Evaporator as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2006 Mercury Montego Evaporator Parts Q&A
- Q: How to service the evaporator core on 2006 Mercury Montego?A: Service of the evaporator core should begin by testing for leaks when a leak is suspected before core removal. The replacement of a new receiver/drier becomes crucial only when failure clues appear from a damaged or contaminated A/C compressor or receiver/drier damage. The service process starts by removing the air inlet duct together with the heater core. The procedure starts with removing the eight upper screws holding the evaporator core cover in place before disconnecting the electrical connector of the blower motor speed control apparatus or blower motor resistor and unattaching the wire harness from the evaporator core cover. Begin by removing two screws securing the floor duct before taking out the floor duct and then proceed to eliminate thirteen screws from the evaporator core cover. Finally, remove the evaporator core. To install swap the original removal order and apply the right amount of fresh PAG oil to the refrigerant system.