OEM 2006 Mercury Monterey Seat Cushion

2006 Mercury Monterey Seat Cushion Parts Questions & Experts Answers

• Q: What precautions should be taken when servicing the front driver side seat cushion on 2006 Mercury Monterey?

  A: The front driver side seat cushion servicing demands safety glasses usage to protect against accidental air bag discharges because the air bag module contains sodium hydroxide which irritates skin after deployment. The process should begin only after depowering the supplemental restraint system (SRS) while bearing in mind that removing the RCM fuse with the ignition switch ON will cause the air bag warning lamp to illuminate due to a design feature. This normal lighting does not indicate any system faults exist. Replace all components of the seat backrest as well as the side air bag module and possibly the seat backrest frame after a deployed side air bag. Begin the procedure by taking out the driver seat followed by disabling the SRS and then removing any seat control knob present. After that unlatch the recliner handle cover tab and detach the handle. The LH side shield screw behind the recliner handle must be taken out before the front and rear LH side shield screws followed by seat control switch disconnect if equipped and finally the LH side shield removal. Disconnect the RH side shield after you remove its two screws and detach the shield. The seat side air bag requires electrical connector detachment before running it through the seat cushion frame in order to remove the backrest. During climate-controlled seat maintenance it is necessary to detach the backrest thermo-electric device (TED) electrical connector then remove the backrest climate-controlled seat duct from its connection to the blower. Memory seats require disconnecting three membrane connectors from each motor position sensor and detaching pin-type retainers mounted on the seat cushion frame. Disconnect the 2 heater mat electrical connectors from the backrest heater mat while also removing all electric connectors and pin-type retainers which secure the seat cushion assembly to its frame. Remove all electrical connectors from the safety belt buckle pretensioner before removing its bolt and pretensioner hardware which should be torqued to 40 Nm (30 lb-ft) before reinstallation. To detach the seat backrest from the seat cushion use a torque wrench at 58 Nm (43 lb-ft) to tighten the three manual track bolts or four power track bolts. First disconnect electrical connectors as well as pin-type retainers to detach the seat cushion frame from the seat track and riser system. Put in a torque wrench to secure the 4 seat track-to-seat cushion frame bolts at 25 Nm (18 lb-ft) torque. First detach the J-clips and disassemble the seat cushion hog rings and trim cover before proceeding to the foam pad. The heated seat module should be removed along with disconnecting its wires when present while handling the cushion heater mat with care from the foam pad. To access climate-control seats begin with screw removal of the seat cushion then disconnect the climate-controlled seat duct along with the TED and the seat cushion TED bezel. Next detach electrical connectors from the seat fan motor while extracting 3 screws from the fan motor and the climate-controlled seat module using 2 screws before separating the electrical connector from the module. The process for memory seats begins with disconnecting driver seat module electrical connectors and then removing both the screw and driver seat module. Reinstallation of the driver seat along with reverse disassembly procedure completes the assembly while repowering the SRS.