How to remove and replace the rear left parking brake cable on 2007 Ford Expedition?

Before starting the replacement of the rear left parking brake cable you must relieve the pressure on the parking brake cable system. A hoist should support the vehicle when it sits in neutral gear. You should disconnect the left rear cable from the equalizer and extract the conduit from its bracket by folding two tabs. Install the parking brake cable retainer spring properly after verifying the cables run between suspension links. When replacing the left rear cable you must detach it from its retaining clip and then remove the parking brake cable retainer spring as well as disconnecting the wire from the ABS sensor which might exist. You need to remove the wireform bracket retaining bolt before taking out the bracket along with other components. Lastly reinstall the bracket while tightening the bolt to 17 Nm (13 ft. lbs.). Push the retainer so the conduit becomes loose then detach the cable end fitting from the parking brake shoe lever. The installation ends by performing the reverse steps of removal.

OEM 2007 Ford Expedition Parking Brake Cable

Emergency Parking Brake Release Cable

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

3 Parking Brake Cables found

View related parts
2007 Ford Expedition Rear Cable, Passenger Side Part Number: AL1Z-2A635-A
$66.28 MSRP: $111.27
You Save: $44.99 (41%)
ADD TO CART
Product Specifications
- Other Name: Cable Assembly - Parking Brake; Brake Cable
- Position: Passenger Side
- Replaces: 8L1Z-2A635-A
- Base No.: 2A635A
- Item Weight: 3.90 Pounds
- Item Dimensions: 16.3 x 13.8 x 13.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: AL1Z-2A635-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Ford Expedition Submodels:
- Eddie Bauer, EL Eddie Bauer, EL King Ranch, EL Limited, EL Platinum, EL SSV, EL XL, EL XLT, Funkmaster Flex Edition, King Ranch, Limited, Platinum, SSV, XL, XLT | 6 Cyl 3.5 L GAS, 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS
View related parts
2007 Ford Expedition Front Cable Part Number: 6L1Z-2853-BB
$58.48 MSRP: $98.00
You Save: $39.52 (41%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cable Assembly - Parking Brake; Brake Cable
- Replaces: 2L1Z-2853-BA
- Base No.: 2853
- Item Weight: 1.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L1Z-2853-BB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Ford Expedition Submodels:
- Eddie Bauer, EL Eddie Bauer, EL Limited, EL XLT, King Ranch, Limited, NBX, XLS, XLT, XLT Sport | 8 Cyl 4.6 L GAS, 8 Cyl 5.4 L GAS
View related parts
2007 Ford Expedition Rear Cable, Driver Side Part Number: 7L1Z-2A635-C
$50.49 MSRP: $80.18
You Save: $29.69 (38%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cable Assembly - Parking Brake; Brake Cable
- Position: Driver Side
- Replaces: 2L1Z-2A635-AB, 5L1Z-2A635-B, 6L1Z-2A635-AB
- Base No.: 2A635
- Item Weight: 2.80 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7L1Z-2A635-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2007 Ford Expedition Submodels:
- Eddie Bauer, EL Eddie Bauer, EL King Ranch, EL Limited, EL Platinum, EL SSV, EL XL, EL XLT, Funkmaster Flex Edition, King Ranch, Limited, NBX, Platinum, SSV, XL, XLS, XLT, XLT Sport | 6 Cyl 3.5 L GAS, 8 Cyl 4.6 L GAS, 8 Cyl 5.4 L FLEX, 8 Cyl 5.4 L GAS

2007 Ford Expedition Parking Brake Cable

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Expedition Parking Brake Cable available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Expedition Parking Brake Cable as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Ford Expedition Parking Brake Cable Parts Q&A

Q: How to remove and replace the rear left parking brake cable on 2007 Ford Expedition?
A: Before starting the replacement of the rear left parking brake cable you must relieve the pressure on the parking brake cable system. A hoist should support the vehicle when it sits in neutral gear. You should disconnect the left rear cable from the equalizer and extract the conduit from its bracket by folding two tabs. Install the parking brake cable retainer spring properly after verifying the cables run between suspension links. When replacing the left rear cable you must detach it from its retaining clip and then remove the parking brake cable retainer spring as well as disconnecting the wire from the ABS sensor which might exist. You need to remove the wireform bracket retaining bolt before taking out the bracket along with other components. Lastly reinstall the bracket while tightening the bolt to 17 Nm (13 ft. lbs.). Push the retainer so the conduit becomes loose then detach the cable end fitting from the parking brake shoe lever. The installation ends by performing the reverse steps of removal.