FordParts
My Garage
My Account
Cart
OEM 2007 Ford Expedition Yaw Sensor
Yaw Rate Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Yaw Sensors found
2007 Ford Expedition Yaw Rate Sensor Part Number: 7L1Z-3C187-A
Product Specifications- Other Name: Sensor Assembly; Suspension Yaw Sensor; Steering Wheel Speed Sensor; Yaw Sensor; Sensor
- Manufacturer Note: Lateral/Yaw Sensor
- Base No.: 3C187
- Item Weight: 0.50 Pounds
- Item Dimensions: 6.3 x 2.5 x 2.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7L1Z-3C187-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Expedition Yaw Rate Sensor Part Number: 6L2Z-3C187-AA
Product Specifications- Other Name: Sensor Assembly; Suspension Yaw Sensor; Steering Wheel Speed Sensor; Yaw Sensor; Sensor
- Manufacturer Note: Lateral/Yaw Sensor
- Replaces: 3C5Z-3C187-AB
- Base No.: 3C187
- Item Weight: 0.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-3C187-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Ford Expedition Yaw Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Ford Expedition Yaw Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Ford Expedition Yaw Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Ford Expedition Yaw Sensor Parts Q&A
- Q: How to Service and Repair the Yaw Sensor within the Stability Control Sensor Cluster on 2007 Ford Expedition?A: Service or repair of the yaw rate sensor within the stability control sensor cluster starts with removing the front floor console. You need to disconnect the electrical connector from the stability control sensor cluster followed by removing the four bracket securing bolts. The reinstallation process requires upper bracket bolts to reach a torque setting of 9 Nm (80 inch lbs.) while the lower bolts need to be secured at 40 Nm (30 ft. lbs.). The stability control sensor cluster requires two bolt removal before installation where these bolts should be torqued to 12 Nm (9 ft. lbs.). Reinstall the vehicle by doing the opposite steps when removing the steering column.