FordParts
My Garage
My Account
Cart
OEM 2007 Lincoln Mark LT Throttle Position Sensor
TPS Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Throttle Position Sensors found
2007 Lincoln Mark LT Throttle Position Sensor Part Number: 3L3Z-9B742-A
$353.27 MSRP: $415.00You Save: $61.73 (15%)Product Specifications- Other Name: Kit - Throttle Control; Fuel Injection Throttle Control Actuator; Actuator
- Item Weight: 0.90 Pounds
- Item Dimensions: 2.3 x 4.5 x 4.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3L3Z-9B742-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Lincoln Mark LT Throttle Position Sensor Part Number: 6L2Z-9B989-D
$88.26 MSRP: $145.22You Save: $56.96 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Potentiometer - Engine Throttle; Throttle Pos Sensor; Throttle Sensor; Potentiometer
- Replaces: 3L5Z-9B989-AA, 6L2Z-9B989-B, 6L2Z-9B989-A, DY-1049
- Base No.: 9B989
- Item Weight: 0.40 Pounds
- Item Dimensions: 8.3 x 7.7 x 7.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-9B989-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2007 Lincoln Mark LT Throttle Position Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Lincoln Mark LT Throttle Position Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Lincoln Mark LT Throttle Position Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2007 Lincoln Mark LT Throttle Position Sensor Parts Q&A
- Q: How to Properly Handle the Throttle Position Sensor on a 2007 Lincoln Mark LT?A: Service of the throttle position sensor (TP) begins by disconnecting the electric connection. Safe removal of TP sensor screws requires special attention because this process demands starting with hand tool loosening of two turns then finishing with a high-speed driver to take out the screws. Discard the two screws together with the TP sensor unit. Always use new installation components for the TP sensor since the reuse of old parts is not authorized. The radial locator tab on the sensor needs alignment with the radial locator hole present on the throttle body when installing the new TP sensor. Set the new TP sensor into position and apply the two new screws correctly by tightening them to 3 Nm (27 lb-in). Reconnect the electrical connector of the TP sensor as the final installation step.