My Garage
Cart

OEM 2007 Lincoln Town Car Dimmer Switch

Light Dimmer Switch
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Dimmer Switch found

  • 2007 Lincoln Town Car Dimmer Switch Diagram - 3W1Z-11691-AA
    View related parts
    Product Specifications
    • Other Name: Resistor Assembly; Headlight Dimmer Switch; Instrument Light Rheostat
    • Manufacturer Note: Thumbwheel design
    • Base No.: 11691
    • Item Weight: 0.30 Pounds
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 3W1Z-11691-AA
    • Warranty: This genuine part is guaranteed by Ford's factory warranty.
    More Info
    Fits the following 2007 Lincoln Town Car Submodels:
    • Cartier, Cartier L, Designer Series, Executive, Executive L, Executive Protection Series, Protection Series, Signature, Signature L, Signature Limited, Ultimate, Ultimate L | 8 Cyl 4.6 L FLEX, 8 Cyl 4.6 L GAS

2007 Lincoln Town Car Dimmer Switch

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2007 Lincoln Town Car Dimmer Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2007 Lincoln Town Car Dimmer Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2007 Lincoln Town Car Dimmer Switch Parts Q&A

  • Q: How to service and repair the headlamp dimmer switch on 2007 Lincoln Town Car?
    A: Grounding out the battery is the first step to work on the headlamp dimmer switch for repair purposes. The service begins with removing the tilt release lever/handle from the system. The service of the headlamp dimmer switch requires technicians to first uninstall both steering column shrouds by removing three screws after pressing inward on their sides. Tighten these screws to 2 Nm (18 inch lbs) before reinstalling. First disconnect the multi-function switch electrical connectors, proceed by removing the two screws then fasten the switch to 3 Nm (27 inch lbs) torque during assembly. The completion of the process requires performing the removal method in reverse order.