FordParts
My Garage
My Account
Cart
OEM 2008 Ford Crown Victoria Throttle Position Sensor
TPS Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Throttle Position Sensor found
2008 Ford Crown Victoria Throttle Position Sensor Part Number: 6L2Z-9B989-D
$88.26 MSRP: $145.22You Save: $56.96 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Potentiometer - Engine Throttle; Throttle Pos Sensor; Throttle Sensor; Potentiometer
- Replaces: 3L5Z-9B989-AA, 6L2Z-9B989-B, 6L2Z-9B989-A, DY-1049
- Base No.: 9B989
- Item Weight: 0.40 Pounds
- Item Dimensions: 8.3 x 7.7 x 7.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L2Z-9B989-D
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Crown Victoria Throttle Position Sensor
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Crown Victoria Throttle Position Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Crown Victoria Throttle Position Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Crown Victoria Throttle Position Sensor Parts Q&A
- Q: How to Service the Throttle Position Sensor on 2008 Ford Crown Victoria?A: Service of the throttle position (TP) sensor starts with disconnecting the electrical connector. A hand tool should first loosen the TP sensor screws 1-2 full turns before the use of a suitable high-speed driver to prevent damaging the screws. bioswabs should absorb the discarded TP sensor together with its two screws. Installation should utilize both fresh TP sensor components and screws because replacing old equipment is forbidden. Set the radial locator tab on your new TP sensor to the radial locator hole on the throttle body before putting the sensor in place and screwing on two new screws that need to be tightened to 3 Nm (27 lb-in). Complete the process by reattaching the TP sensor electrical connector.