OEM 2008 Ford E-150 Shift Cable

2008 Ford E-150 Shift Cable Parts Q&A

• Q: How to service and repair the Shift Cable and bracket for the 4R70E and 4R75E on 2008 Ford E-150?

  A: To service and repair the shift cable and bracket for the 4R70E and 4R75E, begin by removing the steering column opening lower finish panel by pulling to release the retaining clips, followed by the removal of the steering column opening lower finish panel reinforcement, which involves releasing the pin-type retainers and disconnecting the electrical connector, removing the screw and data link connector (DLC), and then removing the bolts, tightening them to 9 Nm (80 lb-inch) upon reinstallation. The connector between the shift cable and steering column shift tube lever needs detachment followed by releasing the locking tab from its position on the steering column bracket. Pull the rubber grommet and the shift cable through the bulkhead while having the vehicle in neutral position and installed on the hoist. Remove the locking tab from the shift cable at the manual control lever before detaching the cable bracket by removing its bolts and tightening them to 28 Nm (21 lb-ft) upon reinstallation. Before installing the shift cable, users must secure both locking tabs while ensuring the cable end snaps onto the ball stud and listen for a detection signal when pressing the cable into place. Check the locked position of the shift cable through pulling action then perform needed adjustments on the cable as you proceed.