How to Service the Engine Oil Pressure Switch on 2008 Ford Focus?

To maintain the engine oil pressure (EOP) switch, lift the car in neutral and loosen the electrical connector and press the switch out. Use thread sealant on the new switch and tighten to 15 Nm (11 lb-ft) and then do the reverse, which is the removal process to complete the installation process.

OEM 2008 Ford Focus Oil Pressure Switch

Oil Pressure Sender Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Oil Pressure Switch found

View related parts
2008 Ford Focus Pressure Switch Part Number: G1CZ-9278-B
$24.73 MSRP: $39.27
You Save: $14.54 (38%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Switch Assembly - Oil Pressure; Engine Oil Pressure Switch; Oil Pressure Sending Unit; Oil Pressure Switch
- Replaces: 1U5Z-9278-GA, SW-6376, 6U5Z-9278-G, G1CZ-9278-A
- Item Weight: 0.30 Pounds
- Item Dimensions: 3.1 x 1.7 x 1.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: G1CZ-9278-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2008 Ford Focus Submodels:
- S, SE, SEL, SES | 4 Cyl 2.0 L GAS

2008 Ford Focus Oil Pressure Switch

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Focus Oil Pressure Switch available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Focus Oil Pressure Switch as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2008 Ford Focus Oil Pressure Switch Parts Q&A

Q: How to Service the Engine Oil Pressure Switch on 2008 Ford Focus?
A: To maintain the engine oil pressure (EOP) switch, lift the car in neutral and loosen the electrical connector and press the switch out. Use thread sealant on the new switch and tighten to 15 Nm (11 lb-ft) and then do the reverse, which is the removal process to complete the installation process.