FordParts
My Garage
My Account
Cart
OEM 2008 Ford Ranger Wiper Pivot
Windshield Wiper Pivot- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Wiper Pivots found
2008 Ford Ranger Wiper Pivot, Driver Side Part Number: 6L5Z-17567-AA
$20.58 MSRP: $28.01You Save: $7.43 (27%)Product Specifications- Other Name: Arm And Pivot Shaft Assembly; Windshield Wiper Linkage, Left; Arm & Pivot Assembly; Wiper Linkage
- Position: Driver Side
- Replaces: F77Z-17567-CA
- Base No.: 17566
- Item Weight: 1.20 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L5Z-17567-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Product Specifications- Other Name: Arm And Pivot Shaft; Windshield Wiper Linkage, Front Right, Right; Front Pivot & Arm Assembly; Arm & Pivot Assembly; Arm And Pivot Shaft Assembly; Wiper Linkage
- Position: Front Passenger Side
- Replaces: F77Z-17566-BA
- Base No.: 17566
- Item Weight: 2.20 Pounds
- Item Dimensions: 15.2 x 7.4 x 5.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6L5Z-17566-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Ford Ranger Wiper Pivot
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Ranger Wiper Pivot available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Ranger Wiper Pivot as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Ranger Wiper Pivot Parts Q&A
- Q: How to service the Wiper Pivot and mounting arm on 2008 Ford Ranger?A: Start the wiper mounting arm pivot shaft servicing by positioning the windshield wiper blades in a straight UP position and disconnecting the battery ground cable first. Pull up the pivot arm and release the retainer tab during pivot arm removal for both the right-hand (RH) and left-hand (LH) windshield wipers. After positioning the PCM connector and harness, disconnect the PCM electrical connector by loosening the bolt and removing the nut and stud. Begin by removing both screws from the RH access cover while removing it from its position and then move the power distribution box to extract the LH access cover through the corresponding process. Insert your hand through the RH access cover opening to pull out the wiper motor clip from the middle of the RH mounting arm and pivot shaft. Remove the RH windshield wiper mounting arm and pivot shaft from the LH counterpart before moving them away from the windshield wiper motor. Fasten the pivot nuts on both sides by tightening them to 12 Nm (9 lb-ft). Route the RH and LH mounting arm and pivot shafts out of their respective opening in the RH access region. Install the adapter to the wiper motor crank pin only while making sure the connecting arm clip is fully set because this prevents windshield wiper adapter or arm clip damage. Fit the RH windshield wiper mounting arm and pivot shaft onto the windshield wiper motor crank pin and let it snap into place before finishing by reversing the removal steps while tightening components to 9 Nm (80 lb-in) according to specifications.