Manufacturer Note: Less pump #17664, washer tank only, refer to 8A080 for coolant tank, with 2.3, without low fluid sensor
Base No.: 17618
Item Weight: 2.00 Pounds
Item Dimensions: 15.5 x 11.6 x 11.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 1L5Z-17618-AA
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
More Info
Fits the following 2008 Ford Ranger Submodels:
Edge, Sport, STX, Tremor, XL, XLT | 4 Cyl 2.3 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 4.0 L GAS
2008 Ford Ranger Washer Reservoir
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Ranger Washer Reservoir available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Ranger Washer Reservoir as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Ford Ranger Washer Reservoir Parts Questions & Experts Answers
Q: How to service and repair the windshield washer reservoir and pump for the 3.0L (2V) and 4.0L SOHC engines on 2008 Ford Ranger?
A: One should read the product label cautions thoroughly alongside checking the Material Safety Data Sheet (MSDS) when available for the windshield washer reservoir and pump service and repair process on 3.0L (2V) and 4.0L SOHC engines because improper following instruction results in severe personal injuries. Draining the reservoir fluid beforehand prevents the spilling of windshield washer fluid during windshieldwasher reservoir removal. Begin by plugging the outlet ports of the engine coolant overflow reservoir after you disconnect its overflow hoses. You must first disconnect the electrical connector from the windshield washer reservoir pump before taking out the air cleaner assembly. The windshield washer reservoir requires independent servicing by removing the two bolts and reservoir nuts before extracting it from the vehicle while tightening new components to 6 Nm (53 lb-in). Sever the windshield washer hose from the washer pump after making sure the rubber grommet remains undamaged while extracting the pump from its reservoir. Finish the installation by undoing all steps that were used for removal.