OEM 2008 Ford Ranger Wiper Motor

2008 Ford Ranger Wiper Motor Parts Questions & Experts Answers

• Q: How to service the windshield wiper motor on 2008 Ford Ranger?

  A: The first step to service the windshield wiper motor requires positioning wiper blades straight UP while also unplug the ground battery cable. The windshield wiper motor does not admit repairs because replacement of a new motor becomes necessary when damage or wear occurs. The windshield wiper motor electrical connector must be disconnected while the PCM connector along with its harness need placement away from the work area. First loosen the bolt then take out the nut and stud before disconnecting the PCM electrical connector while setting aside the harness. Proceed with the removal of the RH access cover after unscrewed screws and removing the cover from position. The wiper motor clip can be dislodged through the RH access cover opening from the RH mounting arm and pivot shaft. Move both the RH windshield wiper mounting arm and pivot shaft apart from the LH windshield wiper mounting arm and pivot shaft by disconnecting them. Use a wrench to comply with the torque value at 9 Nm (80 lb-in) when installing the windshield wiper motor after you detach its stud and bolts. Install the motor crank pin retainer clip only when the clip completely.engages with its mounting position before continuing with the installation process. Follow these steps when installing the LH mounting arm and pivot shaft to the motor ahead of the RH mounting arm and pivot shaft while finishing up by performing the removal steps backward and tightening every connection to 9 Nm (80 lb-in).