OEM 2008 Ford Taurus Air Bag Sensor

2008 Ford Taurus Air Bag Sensor Parts Q&A

• Q: How to Service the Air Bag Sensor in the Second Row, C-Pillar on 2008 Ford Taurus?

  A: Before accessing the second row C-pillar side impact sensor the vehicle must undergo crash-free inspection to check the restraints control module (RCM) and impact sensor mounting areas for deformities. Restoration of original production shapes is required if these areas show damage. The installation of new RCM components with sensors should take place no matter what state the air bags are in to ensure complete safety of passengers. Memory saver devices cause unnecessary risks by activating air bags unintentionally so they must be avoided. The removal of RCM fuse while the ignition is on will cause the air bag warning indicator to light up which is normal and does not reflect an SRS malfunction. A vehicle must be released only after the SRS system demonstrates complete functionality without any detected defects. You must install new components for repairs but you should replace the original part while running another diagnostic procedure when the problem endures. The first step is to turn off SRS power before removing the rear seat bolster and disconnecting the side impact sensor electrical connector. You must fasten both the RCM and impact sensor components to their specified torque value for correct functioning. The side impact sensor position along with its locating tab needs to be noted for proper reinstallation while maintaining clean mating surfaces. You should remove the bolt together with the side impact sensor before installing the new sensor while applying 12 Nm (9 lb-ft) of torque. As the last step return to the initial procedure sequence to activate the SRS system.