How to service the knock sensor (KS) on 2008 Ford Taurus?

The service of the knock sensor (KS) requires starting by taking out the thermostat housing before removing the lower intake manifold and coolant tube and discarding the O-ring seal. You need to disconnect the KS electrical connector and then remove its securing two bolts. Follow these steps for installing the new knock sensor by lubricating its new O-ring with clean engine coolant and securing the bolts to 20 Nm (15 lb-ft) torque. Then execute the bolts' removal procedure in reverse order.

OEM 2008 Ford Taurus Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Knock Sensor found

View related parts
2008 Ford Taurus Knock Sensor Part Number: 7T4Z-12A699-A
$68.21 MSRP: $108.31
You Save: $40.10 (38%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Engine Knock; Ignition Knock (Detonation) Sensor
- Replaces: 7T4Z-12A699-AB
- Item Weight: 0.30 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 7T4Z-12A699-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2008 Ford Taurus Submodels:
- Limited, SE, SEL, SHO | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS

2008 Ford Taurus Knock Sensor

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Taurus Knock Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Taurus Knock Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2008 Ford Taurus Knock Sensor Parts Q&A

Q: How to service the knock sensor (KS) on 2008 Ford Taurus?
A: The service of the knock sensor (KS) requires starting by taking out the thermostat housing before removing the lower intake manifold and coolant tube and discarding the O-ring seal. You need to disconnect the KS electrical connector and then remove its securing two bolts. Follow these steps for installing the new knock sensor by lubricating its new O-ring with clean engine coolant and securing the bolts to 20 Nm (15 lb-ft) torque. Then execute the bolts' removal procedure in reverse order.