How to Service the Yaw Sensor on 2008 Ford Taurus?

The service of the yaw rate sensor requires the removal of the front floor console. First detach the electrical connector of the stability control sensor cluster then remove its electrical harness retainers before they go on the side. The stability control sensor cluster needs its two bracket bolts removed before you can take it out while ensuring proper tightness of 12 Nm (9 lb-ft) after reinstallation. Finish installation by executing the reverse order of steps used for removal. Installation of a new stability control sensor cluster requires ABS module calibration through the directions of the scan tool according to the calibration procedures.

OEM 2008 Ford Taurus Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Yaw Sensor found

View related parts
2008 Ford Taurus Yaw Rate Sensor Part Number: 8G1Z-3C187-A
Product Specifications
- Other Name: Sensor Assembly; Suspension Yaw Sensor; Yaw Sensor
- Manufacturer Note: Sensor - Yaw
- Base No.: 3C187
- Item Weight: 0.40 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8G1Z-3C187-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
More Info
Fits the following 2008 Ford Taurus Submodels:
- Limited, SE, SEL, SHO | 4 Cyl 2.0 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS

2008 Ford Taurus Yaw Sensor

If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Ford Taurus Yaw Sensor available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Ford Taurus Yaw Sensor as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.

2008 Ford Taurus Yaw Sensor Parts Q&A

Q: How to Service the Yaw Sensor on 2008 Ford Taurus?
A: The service of the yaw rate sensor requires the removal of the front floor console. First detach the electrical connector of the stability control sensor cluster then remove its electrical harness retainers before they go on the side. The stability control sensor cluster needs its two bracket bolts removed before you can take it out while ensuring proper tightness of 12 Nm (9 lb-ft) after reinstallation. Finish installation by executing the reverse order of steps used for removal. Installation of a new stability control sensor cluster requires ABS module calibration through the directions of the scan tool according to the calibration procedures.