FordParts
My Garage
My Account
Cart
OEM 2008 Lincoln Mark LT Throttle Body
Fuel Injection Throttle Body- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Throttle Body found
2008 Lincoln Mark LT Throttle Body Part Number: 8L3Z-9E926-C
$287.16 MSRP: $460.00You Save: $172.84 (38%)Product Specifications- Other Name: Throttle Body And Motor Assembly; Electronic Fuel Injection Throttle Body Assembly.
- Replaces: 8L3Z-9E926-B, 6L3Z-9E926-A, 8L3Z-9E926-A
- Base No.: 9E926
- Item Weight: 10.60 Pounds
- Item Dimensions: 10.5 x 7.1 x 6.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8L3Z-9E926-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2008 Lincoln Mark LT Throttle Body
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2008 Lincoln Mark LT Throttle Body available at FordPartsDeal.com. You can confidently purchase our OEM 2008 Lincoln Mark LT Throttle Body as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2008 Lincoln Mark LT Throttle Body Parts Q&A
- Q: How to service and repair the throttle body on 2008 Lincoln Mark LT?A: The procedure to service the throttle body starts with flame and smoking area avoidance around all fuel components since the pieces contain potentially explosive mixtures. You should first take off the air cleaner and its intake pipe. Disconnect both the electronic throttle control electrical connector and the throttle position (TP) sensor electrical connector from their places. Start by removing the four bolts from the throttle body followed by taking off the throttle body unit while discarding its old O-ring seal. The installation requires a new throttle body O-ring seal that needs clean engine coolant as a lubricant before its placement. The bolts should be tightened to 9 Nm (80 lb-in) and an additional 90-degree (1/4-turn) should follow. The installation process ends by performing the reverse actions of the removal phase.