FordParts
My Garage
My Account
Cart
OEM 2009 Ford E-150 Drive Shaft
Axle Shaft- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Drive Shafts found
2009 Ford E-150 Drive Shaft, Rear Part Number: 5C2Z-4602-G
$334.83 MSRP: $453.85You Save: $119.02 (27%)Product Specifications- Other Name: Shaft Assembly - Drive; Drive Shaft, Rear; Driveshaft
- Position: Rear
- Replaces: 3C2Z-4602-SA, 5C2Z-4602-GB
- Base No.: 4602
- Item Weight: 25.90 Pounds
- Item Dimensions: 6.2 x 6.1 x 55.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5C2Z-4602-G
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford E-150 Drive Shaft Part Number: 8C2Z-4602-C
$606.38 MSRP: $829.23You Save: $222.85 (27%)Product Specifications- Other Name: Shaft Assembly - Drive; Driveshaft
- Replaces: 8C2Z-4602-B, 8C2Z-4602-A
- Base No.: 4602
- Item Weight: 25.60 Pounds
- Item Dimensions: 6.3 x 6.2 x 56.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 8C2Z-4602-C
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford E-150 Drive Shaft
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford E-150 Drive Shaft available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford E-150 Drive Shaft as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford E-150 Drive Shaft Parts Q&A
- Q: How to Remove and Replace the Rear Two-Piece Drive Shaft on 2009 Ford E-150?A: You must start by putting the vehicle in neutral gear when working on the rear two-piece driveshaft while the vehicle rests on a hoist. You should first mark the driveshaft at the rear axle pinion flange before removing the four bolts that secure the rear driveshaft section. Before starting support the coupling shaft while removing its two center bearing bracket bolts. First index-mark the driveshaft flange and its transmission position before removing the driveshaft through the 4 bolts that need discarding. During installation use the indexed marks to correctly position the driveshaft before inserting the 4 new driveshaft bolts which need to be tightened to 103 Nm (76 lb-ft). Safely position the coupling shaft while placing the center bearing onto its bracket. Fasten these two center bearing bracket bolts to a torque of 63 Nm (46 lb-ft). When installing the rear driveshaft section position the driveshaft flange yoke on the pinion flange at its index marks while securing the 4 driveshaft-to-pinion flange bolts with 112 Nm (83 lb-ft) torque.