FordParts
My Garage
My Account
Cart
OEM 2009 Ford Edge Brake Booster
Brake Power Booster- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Brake Booster found
2009 Ford Edge Brake Booster Part Number: AT4Z-2005-A
$180.68 MSRP: $300.00You Save: $119.32 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Booster Assembly - Brake; Power Brake Booster; Power Booster
- Replaces: 7T4Z-2005-A, 8T4Z-2005-A
- Base No.: 2005
- Item Weight: 8.20 Pounds
- Item Dimensions: 12.6 x 12.2 x 12.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: AT4Z-2005-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Edge Brake Booster
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Edge Brake Booster available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Edge Brake Booster as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Edge Brake Booster Parts Q&A
- Q: How to service and repair the vacuum brake booster on 2009 Ford Edge?A: Servicing the vacuum brake booster begins with removing the stoplamp switch when the brake pedal rests at its position. Maintain compression on the plunger before rotating the bracket. Removing the switch while its plunger is extended will damage the device. The brake booster check valve needs disconnecting from the brake booster before master cylinder seal removal from the booster. The vacuum hose assembly should be directed properly to bypass surrounding components before vacuum hose and wire harness disconnection from their studs to place them aside. The brake booster push rod pin and clip must be removed before detaching the push rod from the brake pedal along with removing the four brake booster nuts which should be tightened to 23 Nm (17 lb-ft) during installation. Put the stoplamp switch together with the attached booster push rod when the brake pedal sits in the at-rest position to ensure proper adjustment and protection of the switch during the installation which follows the removal process in reverse.