FordParts
My Garage
My Account
Cart
OEM 2009 Ford Fusion Power Steering Pump
Power Steering Pump Unit- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Power Steering Pumps found
2009 Ford Fusion Power Steering Pump Part Number: 6E5Z-3A696-AB
Product Specifications- Other Name: Pump Assembly - Power Steering
- Manufacturer Note: With Pulley
- Base No.: 3A674
- Item Weight: 8.50 Pounds
- Item Dimensions: 7.9 x 8.1 x 5.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-3A696-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Fusion Power Steering Pump Part Number: 6E5Z-3A696-B
Product Specifications- Other Name: Pump Assembly - Power Steering; Power Steering Reservoir; Power Steering Pump Reservoir
- Manufacturer Note: With Pulley
- Replaces: 6E5Z-3A696-AA
- Base No.: 3A674
- Item Weight: 7.80 Pounds
- Item Dimensions: 8.1 x 7.6 x 7.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 6E5Z-3A696-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Ford Fusion Power Steering Pump
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Ford Fusion Power Steering Pump available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Ford Fusion Power Steering Pump as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Ford Fusion Power Steering Pump Parts Q&A
- Q: How to service and repair the power steering pump for the 2.3L engine on 2009 Ford Fusion?A: A proper suction device needs to empty the power steering fluid from the reservoir before starting power steering pump maintenance on the 2.3L engine. First detach the accessory drive belt before releasing the clamp to disconnect the power steering return hose from the fluid reservoir. Disconnect the power steering pressure switch electrical connector before removing the pressure line banjo bolt and disconnecting the line while discarding both components. During installation of the new line apply torque to the new bolt until it reaches 35 lb-ft (48 Nm). Follow by separating the power steering pump with its three bolts before pulling out the pump and fasten new bolts that need tightening at 24 Nm (18 lb-ft). One must always replace both a new bolt and new seals when disconnecting the power steering pressure line from the pump to avoid fluid leakage. The power steering system filling process should be done after following all removal steps backward.