FordParts
My Garage
My Account
Cart
OEM 2009 Mercury Mountaineer Sway Bar Link
Stabilizer Sway Bar Link- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Sway Bar Links found
2009 Mercury Mountaineer Stabilizer Link, Front Part Number: 6L2Z-5K483-AA
$26.79 MSRP: $42.55You Save: $15.76 (38%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Link; Front Suspension Stabilizer Bar Link Kit; Sway Bar Link
- Position: Front
- Base No.: 5K483
- Item Weight: 2.00 Pounds
- Item Dimensions: 19.6 x 6.1 x 0.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 6L2Z-5K483-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Mercury Mountaineer Stabilizer Link, Rear Part Number: 6L2Z-5K484-BA
$20.04 MSRP: $31.82You Save: $11.78 (38%)Ships in 1 Business DayProduct Specifications- Other Name: Link; Rear Suspension Stabilizer Bar Link Kit; Sway Bar Link
- Position: Rear
- Base No.: 5K484
- Item Weight: 0.70 Pounds
- Item Dimensions: 8.3 x 7.7 x 7.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 6L2Z-5K484-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2009 Mercury Mountaineer Sway Bar Link
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2009 Mercury Mountaineer Sway Bar Link available at FordPartsDeal.com. You can confidently purchase our OEM 2009 Mercury Mountaineer Sway Bar Link as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2009 Mercury Mountaineer Sway Bar Link Parts Q&A
- Q: How to Service and Repair the Front Sway Bar Link on Rear-Wheel Drive on 2009 Mercury Mountaineer?A: The procedure to service front suspension sway bar links in rear-wheel drive vehicles starts with removing both tire and wheel. The service requires discarding two sway bar nuts and their grommets before putting on new nuts which need tightening to 35 Nm (26 lb-ft) at the height of the curb. Begin service by taking off the two sway bar studs and two sway bar links which need disposal. Thoroughly clean all mating surfaces and internal threads on the connection while confirming their absence of foreign contaminants and any thread sealing compound. Use a screwdriver to rotate the sway bar outwards before removing it with the four sway bar bracket bolts and brackets along with bushings while discarding the bolts. New bolts should be installed during reassembly while the technician tightens them to 55 Nm (41 lb-ft) at curb height specifically. Users must understand the difference between left-hand and right-hand sway bar bushings because they must be only installed on their correct sides to avoid damaging the system. In order to install the left-hand side sway bar bushings line up the groove of the bushing with the upset on the sway bar. The installation process requires an inspection of sway bar bushings for damage while removing those on the left-hand side first. Replace any damaged bushings during this stage. The installation process can be finished by carrying out the opposite sequence of removal steps.