OEM Ford Five Hundred Power Window Motor

Ford Five Hundred Power Window Motor Parts and Q&A

• Window Motor, Front Driver Side
  8G1Z-5423395-A
  Q: How to initialize the LH front power window motor on Ford Five Hundred?

  A:

  No obstructions should exist within the window system before attempting to initialize the LH front power window motor. A de-initialized or new LH front power window motor moves proportionally in both up and down directions until it receives initialization. Implementation of new LH front window motor requires following initialization procedures. The original LH front power window motor requires de-initialization before initialization during all instances of removal from the Window Regulator drum housing or when installing new components including a LH front window regulator, window glass, and glass top run and when applying any grease or lubricants to these components. The installation and tightness verification of window glass and window regulator and window motor and glass top run needs to be completed before starting the process. A partial initialization will force the window motor to work exclusively in the proportional UP and DOWN operations without completing full initialization. Perform the de-initialization procedure by turning the ignition key ON and helping with LH front window operation while removing fuse 30 (30A). Next disable the ignition key. Start with the key ON position and engage and maintain LH front window control switch at top position until window stalls in the upper run before releasing the switch after two seconds. To complete this procedure press and keep holding the DOWN switch until the window reaches the last position at the window's lowest run and follow with switch release after two seconds. Perform a final test to verify proper function of proportional UP and DOWN and one-touch UP and DOWN system movements.
• Window Motor, Front Passenger Side
  5F9Z-7423394-AA
  Q: How to service the front Power Window Motor on Ford Five Hundred?

  A:

  Service to the front door window motor requires first removing the door trim panel together with the water shield. The electrical connection for the window motor comes off while you fasten the glass with tape in its desired position. The three window motor screws must be removed before installation but should be tightened to 7 Nm (62 lb-in). The correct order applies to the window motor removal and installation steps. The installation procedure calls for new LH front window motor initialization. You must proceed with de-initialization of the original LH front window motor before performing its second initialization following reinstallation. Initialization of the LH front window motor must be performed after the motor is taken out from the Window Regulator drum housing or when new components like top runs or lubricants are added to the glass run or window regulator.