The procedure for programming keyless entry remote transmitters should happen while the battery has full charge and anti-theft system is unarmed mode and the simultaneous programming of four transmitters at most. First step is to close all doors to stop multiple chimes from interrupting programming. The
Ignition Switch must be taken from position I to position II four times during six seconds before it ends in position 0. The learning mode starts when an LED turns on and a chime sounds. Press any button on the transmitter you wish to program inside a ten-second duration until the system releases a chime and the LED signal to verify the reception of the new encoding. Multiple programming cycles can be executed by the system through automatic 10-second learning sessions up to a maximum of four remote transmitters. The button press inside the learning mode provides the ability to add new transmitters. The system ends learning mode when users place the ignition switch in position III or when new transmitter programming becomes inactive after 10 seconds or exceeds a maximum of four transmitters. Uncorrect programming attempts will not impact previously stored programming codes while your system retains only the newly programmed transmitters for authorization. Complete testing requires verification of the remote locking and unlocking functions through every programmed transmitter.