OEM Ford Freestyle Power Window Motor

Ford Freestyle Power Window Motor Parts and Q&A

• Window Motor, Front Passenger Side
  5F9Z-7423394-AA
  Q: How to service the front Power Window Motor on Ford Freestyle?

  A:

  The service of the front door window motor starts with door trim panel and water shield removal and then front door speaker removal. The first step involves taking off the access hole cover and cutting loose the two door latch electrical connectors. The next step involves removing power from the keyless entry keypad as well as the door locks and the power mirrors if these components apply to the vehicle. Detach the door latch and door lock linkages after clip removal. The procedure to disconnect involves taking out the wiring harness electrical connector from the window motor while placing the wiring harness to the side alongside removal of four harness retainers and grommet which should be pushed through the panel opening. First remove the interior door handle bolt then set the handle aside before tightening it to 7 Nm (62 lb-in) at reinstallation time. Lower the window first when the regulator motor does not work so you can access the glass clamp bolts through the rear hole and front speaker access point. To replace the glass clamps for B-pillar and A-pillar front door windows, use an 8 Nm (71 lb-in) torque. Attend to the window position with tape before lowering the regulator since it reaches the lower track stops. Circumferentially remove 11 bolts from the door module then tighten them to 8 Nm (71 lb-in) before reinstalling with tightness of 12 Nm (9 lb-ft) applied to the three door latch screws. The six wiring harness retainers and two connector retainers connected to the inside of the door module need to be disconnected to feed the wiring harness through the module before removing the front door module. The necessary parts should be transferred when installing a new door module. The installation process ends by following the removal steps in reverse order and performing initialization on new LH front window motors after uninstalling and then initializing the original LH front window motors.
• Window Motor, Front Driver Side
  8F9Z-5423395-A
  Q: How to initialize the LH front Power Window Motor on Ford Freestyle?

  A:

  The LH front door window motor initialization process begins after checking that each component including the window glass and Window Regulator motor as well as the seals and glass top run are correctly installed according to specification. The proportional UP/DOWN and one-touch-DOWN functions are the only operating modes of a new or de-initialized LH front window motor before it completes initialization. You need to do the initialization step before switching the window control because an uninitialed motor cannot perform the one-touch-UP operation. The initialization process becomes necessary whenever adding new window regulators or motors or implementing any procedures which use grease on the window system. One should start the de-initialization procedure by turning the ignition key ON then operating the window control switch in one-touch mode while simultaneously pulling power from the motor through battery cable removal or removing the LH front window motor fuse or disconnecting the motor connector. The motor factory defaults will be restored automatically through this procedure. First ensure the LH front window extends to maximum position then engage key ON power followed by maintaining the window control switch at the second detent in UP position until the window stops at 2 seconds in its glass top run then release the switch. The second detent of the switch serves to activate the window descent when you maintain pressure for two seconds until it reaches its bottom stopping point. Perform the window operation examination to verify the functionality of one-touch-UP and one-touch-DOWN features.