Begin all steering wheel servicing operations by pointing the wheel toward straight ahead while keeping the ignition in the OFF position. Start by eradicating the driver
Air Bag module followed by untightening the steering wheel bolt. For the job use a Differential Bearing Remover since it protects the column bearings during steering wheel removal. Attach the new steering wheel bolt once the old one is discarded by using a torque wrench to set the bolt at 40 Nm (30 lb-ft). The next step requires disconnecting the steering wheel switch electrical connector from the
Clock Spring assembly. The Clock Spring wires should be guided through the steering wheel when this component is taken off. A protective tape should secure the Clock Spring center rotor to the outer housing to prevent its rotation while working. The executing steps to finish the installation involve performing the removal steps in reverse order.