Q: How to remove the Center Console Base on Lincoln Continental?
A: The floor console removal process should begin with disconnecting the battery ground cable. The required procedure includes uncoupling the cellular phone antenna wire and the coaxial cable. The console glove compartment requires removal followed by disconnecting the power point electrical connector and all antenna and coaxial cables attached to the glove compartment. To eliminate the compact disc changer from the vehicle start by disassembling it through screw removal followed by a disconnect of electrical wiring then a removal of the digital audio compact disc player unit. Use gearshift position 1 to begin and then eliminate the console top panel by discharging the cigar lighter electrical connector. Use a screwdriver to uninstall the screws that affix the floor console both to the floor bracket and to the gearshift bracket. You should first disconnect the three electrical connectors before sliding the floor console backward to remove it. To reinstall the component follow all the opposite steps of the removal process. Driving 16 km (10 mi) or more will be needed to reset adaptive learning after performing this procedure to disconnect and reconnect the battery.
Q: How to service the front Center Console Base on Lincoln Navigator?
A: Service of the front floor console requires first activating the parking brake followed by moving the front seat to its furthest position. Reinstall the two rear bolts of the front floor console after you tighten them to 7 Nm (62 lb-in). Switch off the battery power while moving rearward the front vehicle seats. After disconnecting the electrical connectors remove both the pin-type retainer and the window control switch panel. Press NEUTRAL on the shift lever followed by placing the shift indicator bezel to the side. Tear away the screws holding the center console finish panel while disconnecting the shift cable. During installation replace the floor console electrical connectors by first loosening the connector bolt then tightening it to 5 Nm (44 lb-in). Additional electrical connectors must be disconnected according to requirements. Start by taking off the front floor console side finish panels from both left and right sides while disconnecting all electrical connectors that are present. Remove the left-hand and right-hand front floor console front bolts before taking out the floor console itself while tightening all bolts to 7 Nm (62 lb-in) during reinstallation. After removal the procedure can be finalized through the execution of the opposite installation sequence.
Q: How to Remove and Service the Center Console Base for Automatic Transmission on Lincoln LS?
A: The first step to fix or work on the automatic transmission console requires a parking brake application combined with selecting neutral on the selector lever. First disconnect the battery ground cable then eliminate the ashtray finish panel followed by discharging electrical connectors. You should disconnect all electrical connectors of cellular phones present in the vehicle. The console finish panel assembly must now be removed by pulling it upward from its front position. The traction control switch electrical connector needs to be detached when present and the cellular phone wiring harness must be freed from the console finish panel assembly. The installation demands performing the opposite steps compared to the removal process.