OEM Mercury Monterey Wiper Motor

Mercury Monterey Wiper Motor Parts and Q&A

• Wiper Motor
  6F2Z-17508-CARM
  Q: How to service the windshield wiper motor on Mercury Monterey?

  A:

  Service of the windshield wiper motor begins with removing the windshield Wiper Arms. Begin the cowl panel grille removal after disconnecting the washer hose and removing its push-pin type retainers. The second step involves removing the washer hose grommet that is secured to the cowl panel so place the hose aside. The A/C air inlet filter should be removed when it is an applicable service. Start the procedure by removing the nine cowl panel bolts before taking the cowl panel away from the vehicle. Disconnect the electrical connector from the windshield wiper motor then remove the four securing bolts which attach the motor. The wiper pivot arms get installed to the windshield wiper motor while using a bolt with recommended torque of 15 Nm (11 lb-ft). Install the three windshield wiper to cowl panel bolts in place and tighten them to 15 Nm (11 lb-ft). The cowl panel needs reinstallation in the vehicle space before connecting the windshield wiper motor electrical connector. The washer hose installation begins with placing it and the grommet into the cowl panel followed by screwing and tightening the nine bolts to 6 Nm (53 lb-in). Reinstallation of the A/C air inlet filter should be performed if necessary. Fasten the washer hose to the grille before returning it to its position into the vehicle while securing the push-pins afterward. After winding completion check alignment of the wipers by cycling them while installing the windshield wiper arms and nuts with a torque setting of 27 Nm (20 lb-ft).