Q: How to Service and Install the Wiper Arm on Mercury Marauder?
A: You should start servicing the wiper pivot arm by lifting it into its upright position before you can remove it by letting go of the locking tab. When putting together the pivot arm with mounting arm and pivot shaft keep the locking tab pulled to full extension while making sure the key on the pivot arm head matches correctly with the keyway of the shafts. Users can take out the keyway as required. Wiper pivot arm adjustment requires correct procedures when performed. The installation ends with a reverse execution of removal procedures.
Q: How to Service and Repair the Wiper Arm on Mercury Monterey?
A: A technician needs to start arm pivot repair and servicing by unscrewing the windshield wipers from their mounts. You must disconnect the hose before you remove the push-pins from the cowl panel grille for removing the grille. Take the grommet off the washer hose from the cowl panel before placing the hose to the side. Take out the A/C air inlet filter only if it exists. Start by taking out the nine cowl panel bolts before setting the cowl panel to the side. The vehicle requires the cowl panel removal after disconnecting the windshield wiper motor electrical connector. Remove the bolt holding wiper pivot arms to the wiper motor before carefully using a prying motion to remove the wiper pivot arms from the wiper pivot ball and socket. Insert the pivot arm socket onto the pivot ball and press until it reaches complete seat inside the assembly. Mount the pivot arms onto the windshield wiper motor while installing a bolt that needs tightening to 15 Nm (11 lb-ft). Reinstall the cowl panel after putting back the windshield wiper motor electrical connector. Install the washer hose with its grommet through the cowl panel before proceeding to secure the nine cowl panel bolts at 6 Nm (53 lb-in). Refit the A/C air inlet filter only if it needs replacement. You must position the cowl panel grille inside the vehicle after which you must connect the washer hose before inserting the push-pins. Installation of the windshield wiper arms needs to begin with tightening the wiper nuts to 27 Nm (20 lb-ft) before winding and parking the wipers to check their alignment.
Q: How to Service the Wiper Arm Pivot on Mercury Grand Marquis?
A: A proper wiper pivot arm service process involves lifting it to its full height followed by unlocking the tab to remove the wiper pivot arm. When mounting the pivot arm to the mounting arm and pivot shaft keep the locking tab completely opened before proceeding. Conditions for proper alignment exist when the pivot arm head key fits into the shaft keyway; you can remove the keyway if needed for better alignment. Follow the instructions provided under the Windshield Wiper Blade and Pivot Arm Adjustment to tune the wiper pivot arms. Users need to follow the opposite steps for basic installation to finish their work.