Ford 8G1Z-17566-A
Wiper Transmission

Service of wiper mounting arms and pivot shafts starts by taking off the wiper pivot arms and cowl panel grille. The initial step requires disconnecting the electrical connector followed by removing three bolts securing both the wiper mounting arm together with wiper pivot shaft assembly. Follow this process when reinstalling if you want to achieve proper reinstallation by tightening bolts to 8 Nm (71 lb-in) then follow the removal steps back in reverse order while making proper adjustment to wiper pivot arms.

Service of the wiper mounting arm and pivot shaft assembly starts by taking off the cowl panel grille. Professionalism demands that workers avoid separating the wiper motor linkage arm from the wiper motor assembly because detachment leads to incorrect wiper arm parking positions and subsequent damage. You should next turn and position the wiper mounting arm and wiper pivot shaft assembly according to indicated specifications before you remove the three securing bolts. The wiper mounting arm and pivot shaft assembly can be removed from the vehicle after disconnecting the electrical connector to unfasten the wire harness pin-type retainer. When installing either new wiper mounting arm and pivot shaft assembly or new wiper motor ensure that the wiper motor linkage arm and pivot shaft assembly matches the original positions. The new assembly should be positioned while reconnecting the electrical connector and attaching the wire harness pin-type retainer. Secure the three bolts after tightening them to 8 Nm (71 lb-in). After positioning the wiper motor at PARK cycle the final step is to install the cowl panel grille.

Service of wiper mounting arms and pivot shafts starts by taking off the wiper pivot arms and cowl panel grille. The initial step requires disconnecting the electrical connector followed by removing three bolts securing both the wiper mounting arm together with wiper pivot shaft assembly. Follow this process when reinstalling if you want to achieve proper reinstallation by tightening bolts to 8 Nm (71 lb-in) then follow the removal steps back in reverse order while making proper adjustment to wiper pivot arms.