Ford F8RZ-19E616-BA
Actuator Assembly

The service of blend door motor requires users to remove the screws securing the glove box and extract the glove box from its place. The next step requires unclipping the upper footwell trim panel which exists on the passenger side for removal. First disconnect the electrical connector from the blend door motor before removing the screws supporting the motor in place and extracting it. Installation occurs after reverting the steps used for removal.

Start any service work on the Air Recirculation Door Vacuum Control Motor by taking out the radio amplifier first and then the anti-theft/central locking module if it exists. The service starts with unscrewing the glove box retaining screws then extracting the glove box from the vehicle. Disengage and withdraw the upper footwell trim panel which operates on the passenger compartment of the vehicle. First remove the vacuum control actuator through unclipping the actuating rod followed by voiding two screws and disconnecting the vacuum hose. The installation process requires recovering all procedures that were done to remove the system components.

Service and repair process of the footwell vent/duct blend door actuator starts by removing the audio unit then the floor console and instrument panel lower panel. Service or repair of the footwell vent/duct blend door actuator requires first disconnecting electrical connectors from the switch assembly. Disassemble the heater control/audio unit panel through screw removal that will allow the unit to exit its clips. Begin by removing the heater control/audio unit bezel after disconnecting electrical connectors together with vacuum lines. The removal process ends with actuator detachment that requires disconnecting its actuating rod along with vacuum lines and nuts removal. Finish the installation sequence by performing the reversal of the uninstallation steps.

Service and repair of the air door actuator/motor requires starting with the removal of the driver side instrument panel lower panel for accessing the defrost vacuum control motor. The service process requires removing the bolt covers while disassembling the five bolts. The first step involves detaching the actuator by taking off both vacuum lines as well as disconnecting the actuating rod followed by removing the two nuts. Installation should start by following the opposite steps of removal.

The first step in servicing or repairing the Air Door Actuator/Motor for the vacuum control motor on the floor starts with removing the driver side instrument panel lower panel by removing bolt covers then unfastening five bolts. The service work starts with removing the radio chassis followed by the floor console. The actuator removal follows the clearance of other components by unclipping the actuating rod along with hose connector disconnection and two nut removal. The opposite steps required during removal need to be performed for reinstallation.

Starting service and repair of the defrost vent/register blend door actuator requires initial removal of the instrument panel lower panel. Start by disconnecting both the actuating rod and vacuum lines and then remove the securing nuts focused on the actuator. Finish the installation by performing in the reverse order of the removal procedures.

Reverse the removal procedure.

Reverse the removal procedure.

Reverse the removal procedure.