Ford 6C2Z-11654-A
Light Switch

Starting your service of the headlamp switch requires you to disconnect the battery. The knob needs to be positioned at HEAD while you detach the clip with a small screwdriver and release the knob to remove it. Before continuing turn the bezel of the headlamp switch in a counterclockwise direction to extract it. Motor vehicles with tilt column steering should position the steering wheel in its lowest possible position. Before working with vehicles that have a column shift you should engage the parking brake and place the shift lever in its lowest position. Start by removing the audio unit followed by the removal of the two screws resting above the instrument cluster. The instrument panel finish panel must be pulled backward to expose the clips while disconnecting the cigarette lighter and power point electronic connectors. First remove the bolts that fasten the headlamp switch before disconnecting its electrical connector and pulling out the headlamp switch. The installation of the new switch demands reverse execution of removal procedures.

Starting the service and repair process for the 'headlamp switch' requires 'disconnection of the ground cable from the battery'. The service process starts by taking off the instrument panel finish panel followed by unfastening the headlamp switch bolts. First remove the electrical connector before taking out the headlamp switch. The installation requires performing the opposite steps compared to removal. The vehicle requires driving for minimum 16 km (10 mi) after reconnection of the battery for normal operation during the adaptive strategy relearning.

Begin the service of the headlamp switch by disconnecting the battery. Begin by removing both the instrument panel finish panel together with the headlamp switch bolts. The electrical connector must be disconnected before removing the headlamp switch. The battery disconnection will make the vehicle adjust its adaptive strategy during which driving at least 16 kilometers (10 miles) is needed for correct calibration. Use the opposite steps from removal to finish the installation process.

Starting the service and repair process for the 'headlamp switch' requires 'disconnection of the ground cable from the battery'. The service process starts by taking off the instrument panel finish panel followed by unfastening the headlamp switch bolts. First remove the electrical connector before taking out the headlamp switch. The installation requires performing the opposite steps compared to removal. The vehicle requires driving for minimum 16 km (10 mi) after reconnection of the battery for normal operation during the adaptive strategy relearning.

Service and repair of the headlamp switch begins with disconnecting the battery ground cable. The first step to servicing the headlamp switch involves pulling out the knob while using a thin tool to help with its removal. The instrument panel cluster finish panel needs removal after unscrewing its attached screws. Thereafter completely remove the headlamp switch by unscrewing it and removing the switch while also disconnecting its electrical connectors. The opposite order of removal steps should be followed to install the headlamp switch. After the battery disconnect followed by reconnection the vehicle will show unusual drive behavior because it needs to learn its adaptive strategy while Building its adaptive function through a drive distance exceeding 16 km (10 mi).

It may cause some abnormal drive symptoms as the vehicle relearns its adaptive strategy.

Reverse the removal procedure.

The vehicle may exhibit abnormal drive symptoms as it relearns its adaptive strategy, which may require driving the vehicle for 16 km (10 mi) or more to complete the relearning process.