Ford 7A1Z-14D695-AA
Seat Heat Switch, Rear Driver Side

The servicing requires you to remove the door handle bezel that is next to the heated seat switch for the rear seat. The procedure starts with extracting the screw cover from the rear door handle bezel before removing the bezel screw. You can disconnect the rear door handle bezel after taking off the door trim panel. The heated seat switch removal from the rear door handle bezel begins by disconnecting the electrical connector then releasing the clips until the switch can be taken out from behind the rear door handle bezel. An inverse process of removal steps should be followed during installation.

The procedure for servicing the heated seat switch for rear seating begins by taking away the door handle bezel. The first step is removing the rear door handle bezel screw cover after which you should disconnect the rear door handle bezel screw. Once the components are detached it becomes possible to split the rear door handle bezel from the door trim panel. The rear door handle bezel's heated seat switch removal begins with disconnecting electrical connections then unclipping the assembly before grasping the heated seat switch from its place behind the back side of the rear door handle bezel. The installation procedure requires duplicating all steps that were performed at removal time. The selection of heated seat components for this model must be from its designated parts because interchangeable elements across model years or vehicle types create incompatibilities which lead to functional breakdowns and severe accident risks.

Service of the rear seat heated seat switch should begin by taking out the door handle bezel which sits closest to the switch. The first step involves removing the screw cover of the rear door handle bezel followed by taking out the bezel screw. The first step involves removing the two components to which the rear door handle bezel is attached from the door trim panel. The service of the heated seat switch starts by disconnecting the electrical connector and unfastening the clips before removing it from the rear door handle bezel through the back side. The installation procedure requires the backward execution of all prior removal steps.

Service of the second row heated seat switch requires removal of the rear cup holder by releasing its four retainer clips then reinstalling any retained floor console clips to the cup holder before final installation. Before moving on you must remove the two screws from the front floor console rear panel then release its six retainer clips before separating the rear panel. The service process begins with disconnecting electrical connectors while removing the rear panel but takes care to reinstall all remaining retainers from the floor console to the rear cover before final installation. Separate the heated seat switch(es) after their release. The reinstallation process will start with the opposite actions applied during the removal phase.

Disconnect the electrical connector, release the four tabs, and remove the memory SET switch.

Ensure the air bag warning indicator is illuminated by removing the correct Restraints Control Module (RCM) fuse with the ignition ON.

Begin by removing the driver door trim panel.

Disconnect the electrical connector, release the 4 tabs, and remove the memory SET switch through the front of the door trim panel.

No, the left-hand and right-hand switch wiring harness electrical connectors are not interchangeable.

Squeeze the tab at both the top and bottom of the switch, then remove it from the quarter trim panel.