My Garage
Cart
Switches & Sensors

2008 Mercury Mountaineer Temperature Sender

Currently shopping for
2008 Mercury Mountaineer
Change Vehicle
Categories Close X

Currently selected

Other Categories

Air & Fuel Delivery
Belts & Cooling
Body & Hardware
Brakes
Charging & Starting
Driveline & Axles
Electrical
Emission Control & Exhaust
Engine
Headlights & Lighting
Interior & Exterior Trim
Maintenance & Lubrication
Steering
Suspension
Transmission
Categories Close X
2 diagrams found for the vehicle you selected.Select your vehicle options to narrow down results.
  • 1.Air Conditioner & Heater - Condenser, Compressor & Lines (6 Cyl 4.0 L)
    2008 Mercury Mountaineer Switches & Sensors Diagram 1 - Thumbnail
  • 2.Air Conditioner & Heater - Condenser, Compressor & Lines (8 Cyl 4.6 L)
    2008 Mercury Mountaineer Switches & Sensors Diagram 2 - Thumbnail
Sort by:
Ref No.
Ref No.
Part No. & Part Description
Price & Qty.
Part No. &
Part Description
  • 2
    -W701890-S426
    Stud
    Condenser Mount Stud
    • Location: Driver Side;Passenger Side
    • Replaced By: -W701890-S439
    MSRP: $12.00 Your Price: $7.05
    4
    Add To Cart

OEM 2008 Mercury Mountaineer Parts for Switches & Sensors

Genuine OEM 2008 Mercury Mountaineer parts are made using the original design, the high standards, in the Mercury official factories, and all of these ensure that they always fit perfectly and easily. FordPartsDeal.com is a trusted source for finding these authentic OEM Switches & Sensors parts at very competitive prices. Our professional team is here to help you choose the right 2008 Mercury Mountaineer Temperature Sender, and our fast delivery options ensure that your parts are always delivered quickly.

A/C Hose Installation and Repair Tips for 2008 Mercury Mountaineer

  • Q: How to Service and Repair the A/C Hose from Condenser to Evaporator on All on 2008 Mercury Mountaineer?
    A: To service the condenser-to-evaporator line, remove the air cleaner and outlet tube, then recover refrigerant. Remove PCM and bracket, disconnect speed sensor and harness, detach brackets, disconnect fittings and discard O-rings, remove line sections. Reverse to install, install new O-rings, add PAG oil, evacuate and charge after leak testing.
See All Installation and Repair Tips