FordParts
My Garage
My Account
Cart
OEM 2000 Ford Taurus Sway Bar Link
Stabilizer Sway Bar Link- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Sway Bar Links found
2000 Ford Taurus Stabilizer Link, Front Driver Side Part Number: 3F1Z-5K483-A
$30.14 MSRP: $41.01You Save: $10.87 (27%)Product Specifications- Other Name: Link; Suspension Stabilizer Bar Link, Front Left; Suspension Stabilizer Bar Link Kit; Sway Bar Link Kit; Sway Bar Link; Link Assembly; Link End
- Position: Front Driver Side
- Replaces: MEF-175, 3F1Z-5K483-AA
- Item Weight: 1.00 Pounds
- Item Dimensions: 3.4 x 3.5 x 13.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F1Z-5K483-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Taurus Stabilizer Link, Front Passenger Side Part Number: 3F1Z-5K484-A
$30.97 MSRP: $42.14You Save: $11.17 (27%)Product Specifications- Other Name: Link; Front Right Suspension Stabilizer Bar Link Kit; Sway Bar Link; Link Assembly; Link End
- Position: Front Passenger Side
- Replaces: MEF-180, 3F1Z-5K484-AA
- Item Weight: 1.00 Pounds
- Item Dimensions: 3.3 x 3.4 x 12.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 3F1Z-5K484-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
2000 Ford Taurus Sway Bar Link
If you're seeking quality and affordability, look no further than our extensive inventory of genuine 2000 Ford Taurus Sway Bar Link available at FordPartsDeal.com. You can confidently purchase our OEM 2000 Ford Taurus Sway Bar Link as they are supported by the manufacturer's warranty and our hassle-free return policy, alongside the benefit of our fast delivery service.
2000 Ford Taurus Sway Bar Link Parts Q&A
- Q: How to Service and Repair the Sway Bar Link on 2000 Ford Taurus?A: You should start servicing and repairing the sway bar link by removing the wheel assembly with careful attention to not use tools that generate power on nuts to stop damaging sway bar link ball joints or boots. Use the hex holding feature to stabilize the ball joints on the sway bar link before removing the nuts. After that, loosen and disconnect the nuts. Start the sway bar link service by disconnecting (5K484) through nut removal then proceed to remove the sway bar link because both parts must be discarded. New nuts are required during installation and the hex holding feature should be used to stop sway bar link ball joints from turning when securing the nuts. To obtain proper retention of essential parts tighten the nuts to their specified torque settings using a torque wrench and socket.